GE Profile P2B918SEMSS Owner's Manual & Installation Instructions

Also see for P2B918: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions

52When All Hookups Are Completed:MAKE SURE ALL CONTROLS ARE LEFT IN THEOFF POSITION.MAKE SURE THE FLOW OF COMBUSTIONAND VENTILATION AIR TO THE RANGE ISUNOBSTRUCTED.Converting to LP Gas (or converting back to natural gas from LP)This range leaves the factory set for use with naturalgas. If you want to convert to LP gas, the conversionmust be performed by a qualified LP gas installer.The conversion instructions and LP orifices can befound attached to the range next to the pressureregulator.Keep these instructions and the orifices in case youwant to convert back to natural gas.Installation of the range.Operating Instructions Safety InstructionsInstallationInstructionsTroubleshooting TipsConsumer SupportAnti-Tip Device InstallationTo reduce the risk of tipping the range, the rangemust be secured by a properly installed anti-tipbracket. See installation instructions shipped withthe bracket for complete details before attemptingto install.To check if the bracket is installed and engagedproperly, remove the storage drawer or kick paneland look underneath the range to see that theleveling leg is engaged in the bracket. On modelswithout a storage drawer or kick panel, carefullytip the range forward. The bracket should stopthe range within 4 inches. If it does not, thebracket must be reinstalled. If the range is pulledfrom the wall for any reason, always repeat thisprocedure to verify the range is properly securedby the anti-tip bracket. Never completely removethe leveling legs or the range will not be securedto the anti-tip device properly.If you did not receive an anti-tip bracket withyour purchase, call 1.800.626.8774 to receiveone at no cost. (In Canada, call 1.800.561.3344.)For installation instructions of the bracket, visitwww.GEAppliances.com. (In Canada,www.GEAppliances.ca.)