GE Profile JS998SKSS Installation Instructions Manual

Also see for JS998 Series: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

6Installation InstructionsELECTRICAL CONNECTIONSUse only a 3-conductor or a 4-conductorUL-listed range cord. These cords may beprovided with ring terminals on wire and astrain relief device.A range cord rated at 40 amps with 125/250minimum volt range is required. A 50 amprange cord is not recommended but if used, itshould be marked for use with nominal 1-3/8″diameter connection openings. Care shouldbe taken to center the cable and strain reliefwithin the knockout hole to keep the edgefrom damaging the cable.• Because range terminals are not accessibleafter range is in position, flexible serviceconduit or cord must be used.NOTE: If conduit is being used, go to Step 3Dand then to Step 6 or 7.• On some models, a filter capacitor may beconnected between the black and whiteleads on the junction block.ALL NEW CONSTRUCTIONS,MOBILE HOMES ANDINSTALLATIONS WHERELOCAL CODES DO NOTALLOW GROUNDINGTHROUGH NEUTRAL,REQUIRE A 4-CONDUCTORUL-LISTED RANGE CORD.ELECTRICAL REQUIREMENTSCAUTION: For personal safety,do not use an extension cord with thisappliance. Remove house fuse or opencircuit breaker before beginninginstallation.This appliance must be supplied with theproper voltage and frequency, and connectedto an individual properly grounded branchcircuit, protected by a circuit breaker or fusehaving amperage as specified on the ratingplate. The rating plate is located on theoven frame.We recommend you have the electrical wiringand hookup of your range connected by aqualified electrician. After installation, havethe electrician show you where your mainrange disconnect is located.Check with your local utilities for electricalcodes which apply in your area. Failure towire your range according to governingcodes could result in a hazardous condition.If there are no local codes, your range mustbe wired and fused to meet the requirementsof the National Electrical Code, ANSI/NFPANo. 70—Latest Edition. You can get a copyby writing:National Fire Protection AssociationBatterymarch ParkQuincy, MA 02269Effective January 1, 1996, the NationalElectrical Code requires that new construction(not existing) utilize a 4-conductor connectionto an electric range.When installing an electric range in newconstruction, follow Steps 3 and 5 for 4-wireconnection.You must use a 3-wire, single-phase A.C.208Y/120 Volt or 240/120 Volt, 60 hertzelectrical system.If the electrical service provided does notmeet the above specifications, have alicensed electrician install an approved outlet.