GE Profile JS998SKSS Installation Instructions Manual

Also see for JS998 Series: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

SLIDE RANGE INTO OPENINGPosition the range in front of the cabinetopening.Make sure that the glass that overhangsthe countertop clears the countertop.If necessary, raise the unit by loweringthe leveling legs.Push while lifting the range into theopening, until the range is within 2″of engaging the anti-tip bracket.Remove the protective trim from the sideof glass (if provided).Using the adjustable pliers or wrench,carefully screw in the back leveling leguntil the glass overhang comes to reston the countertop.Then carefully screw in the front twoleveling legs (similar to E above) until theglass overhang touches the countertop.Carefully push the range into the openinguntil the countertop fully engages thecontrol panel. The back glass overhangshould cover the cutout opening.GFEDCBA11Adjustable wrenchor pliers11Installation InstructionsINSTALL THE RANGEMake sure the edgeof the countertopfits flush againstthe end of theFront Control PanelCountertopSLIDE RANGE INTO OPENING (cont.)Plug the range cord into the receptacle.Locate the cord in the back of the rangein a manner that it will not touch or bemoved by the drawer.H11Position range cord so thatthere is no interference withthe storage drawerFINAL CHECK OF THE ANTI-TIPBRACKETWhen installation iscomplete and the range isin place, check to be surethat the rear leveling leg isfully inserted into the slotof the Anti-Tip Bracket.12STORAGE DRAWER