GE PVM2070 Installation Instructions Manual

Also see for Profile Spacemaker PVM2070DM: Dimension Guide Owner's manual

GE PVM2070 Installation Instructions Manual Manual pdf 19 page image

USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETC2.19RECIRCULATING (Non-Vented Ductless)INSTALLATION OVERVIEWC1. Attach Mounting Plate to WallC2. Prepare Top CabinetC3. Check Microwave AssemblyC4. Adjust BlowerC5. Mount the Microwave OvenC6. Install Charcoal FilterNOTE:* Make sure the screws for theblower motor and blower coverare re-tightened securely toprevent excessive vibration.• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safety goggles when drilling holesin the cabinet bottom.Installation InstructionsYou need to drill holes for the top support screws anda hole large enough for the power cord to fit through.CPlace the mounting plate against the wall andinsert the toggle wings into the holes in the wallto mount the plate.NOTE: Before tightening toggle bolts and woodscrew, make sure the tabs on the mounting platetouch the bottom of the cabinet when pushed flushagainst the wall and that the plate is properlycentered under the cabinet.CAUTION: Be careful to avoid pinching fingersbetween the back of the mounting plate and the wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.43ATTACH THE MOUNTINGPLATE TO THE WALLC1.Attach the plate to the wall using toggle bolts.At least one wood screw must be used to attachthe plate to a wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall andreattach the toggle wings to 3⁄4″ onto each bolt.1WallMountingPlateSpacing for TogglesMore Than WallThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:2