GE PVM2070 Installation Instructions Manual

Also see for Profile Spacemaker PVM2070DM: Dimension Guide Owner's manual

GE PVM2070 Installation Instructions Manual Manual pdf 13 page image

133MOUNT THE MICROWAVEOVENA4.CHECK FOR PROPERDAMPER OPERATIONA3.USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETYou need to drill holes for the top support screws, ahole large enough for the power cord to fit through,and a cutout large enough for the exhaust adaptor.A2.FOR EASIER INSTALLATION AND PERSONALSAFETY, WE RECOMMEND THAT TWO PEOPLEINSTALL THIS MICROWAVE OVEN.IMPORTANT: Do not grip or use handleduring installation.NOTE: If your cabinet is metal, use the nylongrommet around the power cord hole to preventcutting of the cord.NOTE: We recommend using filler blocks if thecabinet front hangs below the cabinet bottom shelf.IMPORTANT: If filler blocks arenot used, case damage may occur fromovertightening screws.Insert a self-aligning screw through top centercabinet hole. Temporarily secure the oven byturning the screw at least two full turns after thethreads have engaged. (It will be completelytightened later.) Be sure to keep power cordtight. Be careful not to pinch the cord, especiallywhen mounting flush to bottom of cabinet.NOTE: When mountingthe microwave oven,thread power cordthrough hole in bottom oftop cabinet. Keep it tightthroughout Steps 1–3. Donot pinch cord or liftoven by pulling cord.Lift microwave, tilt itforward, and hookslots at back bottomedge onto four lowertabs of mountingplate.Exhaust Adaptor(absent on models shippedfor recirculation exhaust)Blower PlateDamperBack ofMicrowave• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safety goggles when drilling holesin the cabinet bottom.Installation Instructions• Place the microwave in its upright position, with thetop of the unit facing up.• This microwave oven may be shipped assembled fortop exhaust (adaptor installed) or for recirculationexhaust (adaptor absent).• Make sure tape securing damper is removed anddamper pivots easily before mounting microwave.• You will need to make adjustments to assure properalignment with your house exhaust duct after themicrowave is installed.12 Rotate front of ovenup against cabinetbottom.