GE PVM1899 Installation Instructions Manual

Also see for PVM1899: Owner's manual

Contents

GE PVM1899 Installation Instructions Manual Manual pdf 5 page image

Installation Instructions4Checklist for InstallationUse this checklist to verify that you have completed eachstep of the installation process. This can help you avoidcommon mistakes.Refer to detailed instructions for each step in the sectionsfollowing this checklist.1. Before installing the appliance, be sure to verify thecabinet dimensions are correct for your appliance andthat the required electrical connections are present.Make sure the electrical cord provided on the applianceis able to reach to the point of connection.Sections: Location requirements, Electrical installation2. Move the appliance into place in front of the cabinetopening.Section: Removing Packaging3. Remove packaging materials, leaving the bottompackaging on the appliance to avoid damage to thefloor.Section: Removing Packaging4. Remove the mounting plate from the rear of theappliance.Section: Install Appliance - Removing the mountingplate5. Find wall studs.Section: Install Appliance - Finding the wall studs6. Attach the mounting plate to the wall.Section: Install Appliance - Attaching the mounting plateto the wall7. Adapt the microwave blower.Section: Install Appliance - Adapting the microwaveblower8. Prepare the cabinet for mounting.Section: Install Appliance - Preparing cabinet9. At least two persons are needed to lift the appliance; tiltand hook the appliance to the holding plate.Section: Install Appliance - Mounting the microwaveoven10. Push the appliance all the way into place and fasten theholding screws through top cabinet holes.Section: Install Appliance - Mounting the microwaveoven11. Use correct hood exhaust.Section: Install Appliance - Hood exhaust12. Test the microwave oven for proper functioning.Section: Testing operationAlways read and follow the complete installationinstructions contained in this manual.Before You BeginRemoving Packaging1. Remove filter, accessories and hardware. Do not removethe Styrofoam protecting the front of the oven.2. Fold back all four carton flaps fully against carton sides.Then carefully roll the oven and carton over onto the topside. The oven should be resting in the Styrofoam.3. Pull the carton up and off the oven.4. Cut the middle of the outer protective plastic bag toremove the mounting plate.Tools and Parts Needed• Philips head screwdriver• Pencil• Ruler or tape measure and straight edge• Drill• Drill bits: 3/16", 1/2", 5/8"• Gloves• Saw (saber, hole or keyhole)• Stud finder or hammer• Safety goggles• Level• Duct and masking tapeOptional tools• Carpenter square• Tin snips (to cut damper)• Scissors (to cut cabinet template)• Filler blocks or scrap wood pieces (for recessed bottomcabinet installations)