GE Monogram ZV48T Installation Instructions Manual

Also see for ZV30S: Installation instructions Installation instructions

Contents

GE Monogram ZV48T Installation Instructions Manual Manual pdf 8 page image

8REMOVE THE PACKAGING• Lift out the wooden crossmember, as well as the topprotective carton.• Lift out the four “L” shaped polystyrene protectionprofiles.• Remove the protection moldings around the smallercarton box.• Remove the small box housing the motor.• Lift the hood out of the box.CAUTION: Lift the hood by graspingthe outside edges of the inlet opening of the hood.Do not lift the hood by the exhaust opening divider—damage will occur! • Remove the shipping screws holding the woodmounting piece to the back side of the hood.Set aside the wood mounting piece and screwsfor later installation. Do not discard.• Remove the “V” shaped carton insert.• Remove the parts package from the “V” shapedcardboard insert.• Remove the junction box cover and knockout.• Install the strain relief onto the back or top of the hood.• Remove all tape and packing material from the hood,duct transition and motor.Installation PreparationTOOLS AND MATERIALS REQUIRED(NOT SUPPLIED)Pencil and tape measurePliersElectric or battery operated drilland 1/8", 3/8" bits120V 60Hz. 15 or 20 Amp,2-wire with ground. Properlygrounded branch circuit.Key Hole SawHammerWire cutter/stripperStep ladderMetal Snips Saber sawor SawsallWire nutsPhillips and flatbladescrewdrdiversStrain relief forjunction cover.Spirit levelFlashlightSafety glasses10" round metalduct, length tosuit installation.Duct tapeWoodMountingSupport MotorHoodPartsPackageShipping Carton