CHAPTER 4: INTERFACES FRONT PANEL INTERFACEL60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL 4-314– Clearing the event records– Clearing the oscillography records– Clearing fault reports– Changing the date and time– Clearing the breaker arcing current– Clearing energy records– Clearing the data logger– Clearing the user-programmable pushbutton statesTo enter the initial setting or command password:1. Press the MENU key until the SETTINGS header flashes momentarily and the PRODUCT SETUP message appears on thedisplay.2. Press the MESSAGE right arrow until the ACCESS LEVEL message appears on the display.3. Press the MESSAGE down arrow until the CHANGE LOCAL PASSWORDS message appears on the display.4. Press the MESSAGE right arrow until the CHANGE SETTING PASSWORD or CHANGE COMMAND PASSWORD messageappears on the display.5. After the CHANGE...PASSWORD message appears on the display, press the VALUE up or down arrow to change theselection to “Yes.”6. Press the ENTER key and the display prompts you to ENTER NEW PASSWORD.7. Type in a numerical password (up to 10 characters) and press the ENTER key.8. When VERIFY NEW PASSWORD displays, re-type the password and press ENTER.9. When the NEW PASSWORD HAS BEEN STORED message appears, your new Setting (or Command) password is active.4.2.11 Invalid password entryBy default, when an incorrect Command or Setting password has been entered via the faceplate interface three timeswithin five minutes, the LOCAL ACCESS DENIED FlexLogic operand is set to “On” and the L60 does not allow settings orcommand level access via the faceplate interface for five minutes. SECURITY ACCESS LEVEL:Restricted CHANGE LOCAL PASSWORDS CHANGE COMMANDPASSWORD: No CHANGE SETTINGPASSWORD: No ENCRYPTED COMMANDPASSWORD: --------- ENCRYPTED SETTINGPASSWORD: ---------CHANGE SETTINGPASSWORD: NoCHANGE SETTINGPASSWORD: YesENTER NEWPASSWORD: ##########VERIFY NEWPASSWORD: ##########NEW PASSWORDHAS BEEN STORED
