3-58 L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUALCONNECT TO THE L60 CHAPTER 3: INSTALLATION3• View all of the L60 metering values• View the L60 protection summary• Generate a service report3.8.2 Use Quick Connect via the front panel RS232 portTo connect to the UR from a computer using a serial cable:1. Connect a nine-pin to nine-pin RS232 serial cable to the computer and the front panel RS232 port.2. Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista DVD oronline from http://www.gegridsolutions.com/multilin). See the software installation section if not already installed.3. Start the EnerVista UR Setup software, or in EnerVista Launchpad select the UR device to start the software.4. Click the Quick Connect button to open the window.Figure 3-61: Quick Connect window to access a device5. Select the serial Interface and the communications port (COM Port) from the drop-down lists, then click Connect. TheCOM Port is that of the computer.6. The EnerVista software creates a site named “Quick Connect” with a corresponding device also named “QuickConnect” and displays them in the Online Window. Expand the sections to view data directly from the UR device. Usethe Device Setup button to change the site name.Each time that the EnerVista UR Setup software is initialized, click the Quick Connect button to establish directcommunications to the L60. This ensures that configuration of the EnerVista UR Setup software matches the L60 modelnumber.3.8.3 Use Quick Connect via a rear Ethernet portTo connect to a UR using an Ethernet cable:1. In the EnerVista software, click the Quick Connect button. The window opens.
