Installation Instructions1 Ft = 0.3 m1” = 2.5 cm2TOOLS YOU WILL NEEDPencilKnifeTape MeasureLevel2 Phillips Screwdrivers (#1 & #2)Drill with 3/32” BitCenterpunch or NailLOCATE AND INSTALL THE REARHOLDDOWN SUPPORTSSet base pan into the front cabinet microwaveoven cutout and center it right and left. Pushback until the front flange is against the cabinetfront wall. Using the V-notch in the base panfront flange, mark the location of the V-notchon the cabinet to use as a reference.CUTOUT DIMENSIONSAllow 1¼” for the overlap of the Microwave Oven TrimKit over all the edges of the cutout.Dimension Trim Kit CutoutHeight 16¾” 15 ± 1/16 ”Width 26¼” 24 7/8 ± 1/16 ”Min. depth with receptacle outside cutout – 16”Min. depth with receptacle inside cutout – 18”120 volt ¨C 60 Hertz grounded power receptacle.Height1¼” OverlapWidth1” clearancebeyond trim frame(on all sides)1¼” Overlap3” Min.1¼” OverlapDepthWARNING! This trim kit uses air flow from the top,bottom and sides of the trim frame. Blocking the air flow cancause the microwave to function improperly and may causedamage to the microwave.Allow a 1” clearance beyond the edge of the trim frame toprovide proper air flow.FOR INSTALLATION ABOVE A BUILT-IN OVEN:Microwave oven should be installed on a 3/8” plywoodbase and supported by 2 x 4 or 1 x 2 equivalent runnerson all sides. Base must be capable of supporting aminimum of 100 lbs.1AV NotchScrew DSlide the two base support brackets from therear into the slots in the base pan. The tonguesof the base support brackets should protrudeinto the base, be centered in the slot, and beinto the slot as far as they will go. Mark anddrill four 3/32 ” diameter holes. Mount the basesupport brackets using four screws (D). Bothbase support bracket tongues should now becentered in the slotted holes in the base and beinto the base as far as they can go.B120V/60HertzGroundedPower OutletBase SupportBrackets