Installation Microwave OvenInstructions Built-In Trim Kits1BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT ³ Save these instructionsfor local inspector’s use.• IMPORTANT ³ Observe all governing codes andordinances.• Note to Installer – Be sure to leave these instructions withthe Consumer.• Note to Consumer – Keep these instructions for futurereference.• Skill level – Installation of this appliance requires basicmechanical and electrical skills.• Completion time – 1 to 3 hours• Proper installation is the responsibility of the installer.• Product failure due to improper installation is not coveredunder the Warranty.• This kit is for use on models:PEB9159DJ, PEB9159SJ,PEB9159EJ and CEB1599SJ.• This kit and microwave are approved for installation aloneor above any single electric wall oven. Do not mountadjacent (within 2 feet) to any range, cooktop, gas oven, orother microwave.• This product is to be installed 3 feet above floor level.• Do not alter or modify any part of this kit or the oven.• For easier installation and personal safety, werecommend that two people install this microwave oven.• Unplug the microwave oven before attempting installationof this kit.WARNING ³ This oven must be plugged into aproperly grounded 3-hole, 120 volt receptacle as required bythe National Electrical Code.WARNING ³ Before beginning the installation,switch power off at service panel and lock the servicedisconnecting means to prevent power from being switchedon accidentally. When the service disconnecting meanscannot be locked, securely fasten a prominent warningdevice, such as a tag, to the service panel.Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: GEAppliances.comPARTS INCLUDEDNOTE: This kit has extra screws to prevent the technicianfrom spending extra time locating a replacement in casethey lose one during installation.JX9152 and JX9153PART QUANITYRear Duct 1Bottom Duct1Trim KitFrame 1Rail2Short Screws15 required1 extraLong WoodScrews 4 required2 extra