BEFORE YOU BEGIN1Installation Microwave OvenInstructions Built-In Trim KitsRead these instructions completely and carefully.• IMPORTANT – Save these instructionsfor local inspector’s use.• IMPORTANT – Observe all governingcodes and ordinances.• Note to Installer – Be sure to leave theseinstructions with the Consumer.• Note to Consumer – Keep these instructions forfuture reference.• Skill level – Installation of this appliance requiresbasic mechanical and electrical skills.• Completion time – 1 to 3 hours• Proper installation is the responsibility of theinstaller.• Product failure due to improper installation is notcovered under the Warranty.• This kit is for use on models:JEM25WMC, PEM31BMC, PEM31WMC andPEM31SMC.• This kit is cUL listed for installation alone or overany GE/GE Profile single electric wall oven.• For easier installation and personal safety, werecommend that two people install this microwaveoven.• Unplug the microwave oven before attemptinginstallation of this kit.WARNING! This oven must be plugged into aproperly grounded 3-hole, 120 volt receptacle as requiredby the National Electrical Code.PARTS INCLUDEDWARNING! Before beginning the installation,switch power off at service panel and lock the servicedisconnecting means to prevent power from beingswitched on accidentally. When the servicedisconnecting means cannot be locked, securelyfasten a prominent warning device, such as a tag,to the service panel.FOR YOUR SAFETY:Questions? Call 1-800-561-3344 or Visit our Website at: www.GEAppliances.caPARTSJX827QUANTITYBase PanBack CoverSide BracketUpper BracketBottom BracketTrim KitBase SupportBrackets5 mm x 10 mmScrew A4 mm x 10 mmScrew B4 mm x 12 mmScrew C4 mm x 10 mmScrew D4 mm x 16 mmScrew E11111122 required2 extra1 required2 extra4 required2 extra10 required2 extra4 required2 extraNote: This kit has extra screws to prevent thetechnician from spending extra time locating areplacement in case they lose one during installation.