GE JNM7196SFSS Installation Instructions Manual

Also see for DVM7195: Use and care manual Installation instructions Owner's manual Owner's manual Owner's manual

GE JNM7196SFSS Installation Instructions Manual Manual pdf 17 page image

Snip all 4 webson each knockoutpanel andremove the metalknockouts for rearairflow.Locate the two “knockout” plates, on the rear ovenpanel, near the top of the oven.Using tin snips, carefully cut the web area from thetwo holes side-by-side (that secure the knockouts tothe oven). Cut all four webs on both rear knockouts;this will allow the ventilation fan airflow to exhaustout the rear of the oven.CAUTION: Be sure to trim the sharpHGJHVIURPWKHRSHQLQJVDIWHUUHPRYLQJWKHNQRFNRXWSODWHVAFTER: Fan Blade2SHQLQJV)DFLQJ%DFN7 Place the blower unit back into the opening.98Roll the blower unit 90° so that fan blade openingsare facing out the back of the oven.517Blower PlateBefore Rolling After RollingBack ofOvenEnd AEnd BBack ofOvenBack ofOvenWARNING:5LVNRIHOHFWULFVKRFNcan cause injury or death. Do not pull or stretchWKHEORZHUXQLWZLULQJPDNHVXUHWKHZLUHVDUHnot pinched..NOTE: The blower unit exhaust openings shouldmatch exhaust openings on rear of microwave.Installation Instructions2YHQ5HDU3DQHO6Attach the exhaust adaptor to the rear of the ovenby sliding it into the guides at the top center of theback of the oven.Close the blower plate so it is closed over the toptab of the exhaust adapter. Secure with the screwremoved earlier.Push down securely until it is in the lower lockingtabs. Take care to assure the damper hingeis installed so that it is at the top and that thedamper swings freely.Slideexhaustadaptor intoguides onoven rear.Exhaust AdaptorExhaust AdaptorDamper(hinge side up)LockingTabs GuidesBack ofOvenScrewScrew