GE JGBS04 Owner's Manual & Installation Instructions

Also see for Appliances JGBS04: Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions Owner's manual and installation instructions Owner's Manual & Installation Instructions Owner's Manual & Installation Instructions

Contents

GE JGBS04 Owner's Manual & Installation Instructions Manual pdf 31 page image

Installation Instructionsi iAWARNINGJANTI-TIP.DEVICE• All ranges can tip.• BURNSorother SERIOUSINJURIEScan result.-INSTALL and CHECK theANTi-TIP bracket followingthe instructions suppliedWith the bracket.To reduce the risk of tipping the range, the rangemust be secured bg a properly installed anti-tipbracket. See instaftation instructions shipped withthe bracket for complete details before attemptingto install.To check if the bracket is installed and engagedproperly, carefully tip the range forward. The bracketshould stop the range within 4 inches, lf it does not,the bracket must be reinstalled. If the range is pulledfrom the waft for any reason, always repeat thisprocedure to verifg the range is properlg securedby the anti-tip:bracket.For free-standing or slide-in ranges, nevercompletely remove the leveling legs or the range willnot be secured to the anti-tip device properly.ff gou did not receive an anti-tip bracket with gourpurchase, ca!l 1-800-626-8774to receive one'atno cost (in Canada, call 2-800-561G344).Forinstallation instructions of the bracket; visitGEAppliances.com (in Canada, GEAppliances.ca).iLOCATIONDo not locate the range where it mag be subjectto strong drafts. Ang openings in the floor orwall behind the range should be sealed. Hakesure the openings around the base of the rangethat supplg fresh air for combustion andventilation are not obstructed bg carpetingor woodwork.Your range, like mang other household items, isheavg and can settle into soft floor coverings suchas cushioned vingl or carpeting, Use care whenmoving the range on this tgpe of flooring, t isrecommended that the following simple andinexpensive nstructions be followed to protectgour floor.The range should be installed on a sheet ofplgwood (or similar material). When the floorcovering ends at the front of the range, the areathat the range wilt rest on should be built up Withplgwood to the same level or higher than the floorcovering.This wil allow the range to be moved for cleaningor servicing. Also, make sure gour floor coveringwill withstand 180°R (See the Installation SafetyInstructions section.}Hake sure the wall coverings around gout rangecan withstand the heat generated (up to 200°F)bgthe range. (Seethe Installation Safety Instructionssection.]MODEL AND SERIAL NUMBER LOCATIONDepending on gour range, gou'll find the modeland serial numbers on a label on the front frame ofthe range, behind the kick panel or broiler drawer.IMPORTANT!Remove all tape and packaging. Make sure theburners are propertg seated and level.Lift up the cooktop (on models with standardtwin burners) and remove ang packing materialunder it.Take the accessorg pack out of the oven and/ordrawer.Check to be sure that no range parts have comeloose during shipping.!