GE 21825 User Manual

Contents

GE 21825 User Manual Manual pdf 14 page image

14Deregister HSIf several handsets are registered on one base station, they canderegister each other mutually. The last handset can not bederegistered.z Press key until the BASE menu appears and press “Int/ok”key.z Press or key to select the required submenu andpress “Int/ok” key.z Enter the PIN (factory setting = 0000) and press “Int/ok” key.z If necessary, Use or key to select the handset andpress “Int/ok” key.z Press “Int/ok” key to confirm.Technical SpecificationsHandset OperatingTime: (averagevalues*)Approx. 8.5 hours talk timeApprox. 100 hours standbyAC / DC Adaptor VD060035DInput: 230V AC / 50 HzOutput: 6V DC, 350mASingle-phase AC excluding IT installationsdefined by the EN 60950 standard.Caution: the network voltage is classifiedas a hazard by the criteria of this standard.AC / AC Adaptor (forHandset charging)VA070020DInput: 230V AC / 50 HzOutput: 7V AC, 200mASingle-phase AC excluding IT installationsdefined by the EN 60950 standard.Caution: the network voltage is classifiedas a hazard by the criteria of this standard.Telephone connection Appliance designed for connection to ananalogue telephone line class TRT3(telecommunications network voltage) asdefined by the EN 60950 standard.Rechargeable Battery GP60AAAHC, 1.2V / 600mAh / Ni-MH,AAA x 2 or equivalent“WEEE” weight 447g* For guidance only, depends on initial battery charge.General Product CareSimply wipe the base station with a damp cloth or an antistatic wipe.Never use a dry cloth as this can cause static discharge.Periodically clean the charge contacts on the handset, base andcharger with a soft cloth.Troubleshooting GuideWhen you forget base PIN, following the procedure to Reset the units.ALL MEMORY AND SETTING WILL BE LOST.z Refer to handset – Call Log Operation procedure, selectDELETE ALL to delete all Call Log Memories in handset.z Disconnect the line cord and AC power supply.z Hold "PAGE" button and plug in the AC power supply (in-useLED will be on).z Release "PAGE" button after hear two beep tones and press ittwo times again.z The In-Use LED will turn Off.z The unit will return to its default setting a PIN code (0000).z Unplug AC power of base station and plug in again, handsetLCD will display “ ---- ”.z Following “Registering Additional Handsets” to register allhandsets again.

/ 15

Related manuals for GE 21825