GDC SX-2000 Installation Manual

GDC SX-2000 Installation Manual Manual pdf 6 page image

SX-2000 Installation Manual 11/8/2010GDC Technology Ltd. Page 5 of 424 Insert each drive into the hot swap bay while making sure that the grey handle remainsopen:Note: Each hard drive can be inserted into any drive slot. They do not need to beplaced in any particular order.5 Once the content storage drive has been inserted, close the grey handle by pushing ittoward the HDD until it clicks. This will lock in the content storage drive.6 Close and lock the door covering the hard drive bay.2.4 Cable connectionsOnce the server has been placed in the desired location, the cables described below should beattached (See Figure 4).1. VGA cable used for connecting to external touch screen monitor2. Power cables3. Network connectionsa. eth0 – Projectorb. eth1 – Management4. USB slot used for connecting to external touch screen monitor5. PCI-e cableFigure 4 SX-2000 rear panel with cables attached123a3b4 5