Menu
GAS GAS TXe 2019 Owner's Manual
                                            | |
Contents
| 
Owner's Manual-10-65 4REMEMBER TO CLOSE ALWAYS TAPE OF THE RECHARGE PORT(5) TO AVOID DIRTYNESS.Components needed to charge the battery:A - BatteryB - ChargerC – Charger cable to the home networkTo charge the battery, follow the steps below:The connection for charging the battery is in the upper front part of themotorcycle (1).- First make sure that the motorcycle is switched off by the button located onthe right side (2), it must be in the OFF position.- Then unplug the battery connector (pull it out, goes with pressure, (neverpull the cables) do it always from the connector (3)) and connect the chargercable through the three-pin connector to the battery (4).- Connect the cable (5) to the charger and then the other part to the 100-240V domestic network (6). You will see how the indicator LED on thecharger starts blink green to indicate that the battery is charging.- The led will become fixed green when the battery is fully charged. Itwill take approximately 2.5 hours for a full charge.- After charging, unplug the charger from the socket and, only afterwards,disconnect the charger from the battery. Reconnect the connector (3) of themotorcycle to the battery. At this moment your TXe will be ready to use it.Battery charging13 2ABCTO EXTEND THE LIFE OF YOUR BATTERY, AVOID HALF LOADS.¡WAIT THE LED BECOMES GREEN! |
Related manuals for GAS GAS TXe 2019
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved