Fujitsu Eternus DX100 S3 User Manual

Also see for Eternus DX200F: Configuration guide Configuration guide Configuration guide Safety precautions Configuration guide

Contents

Appendix A Error Messages/Error CodesA.2 Error CodesETERNUS CLI User’s GuideCopyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0881A.2 Error CodesThs section explains error codes.A.2.1 Copy Session Error CodesTable 1.2 List of copy session error codesError code Description0x10 – 0x1F An error that is caused by a copy source volume occurs. Some copy source volumes can-not be accessed because a failure has occurred in a component (e.g. drives and driveenclosures).0x20 – 0x2F An error that is caused by a copy destination volume occurs. Some copy destination vol-umes cannot be accessed because a failure has occurred in a component (e.g. drivesand drive enclosures).0x30 – 0x3F An error occurred due to a copy path or an REC buffer HALT occurred.0xBA Bad data exists.0xBB SDV/SDP capacity is insufficient.0xBD Overload status is detected in a copy destination volume or a copy destination storagesystem.0xBE A copy path has failed. Data is stored in the REC Buffer. This error is displayed onlywhen the "Type" is "REC".0xBF A copy path has failed. Data is stored in the REC Disk Buffer. This error is displayed onlywhen the "Type" is "REC".Error codes other than above An error other than the ones listed above occurs.