Chapter 3 Configuration Settings and Display3.5 Host Interface Management > set lun-groupETERNUS CLI User’s GuideCopyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0328set lun-groupThis command changes an existing LUN group and can also be used to add a definition to the LUN group.■ Syntax■ Parameterset lun-group {-lg-numbersource_lg_number | -lg-namesource_lg_name } [-namename][{-volume-numbervolume_numbers | -volume-namevolume_names} {-lunluns}]-lg-numberor-lg-nameThis parameter specifies the LUN group identifier to be changed. Only one LUN group can bespecified at the same time. For details, refer to "1.2.12 LUN Group Syntax" (page 28).source_lg_numberLUN group numbersource_lg_nameLUN group name-name Optional. This parameter specifies the new LUN group name. Only one name can be specifiedat the same time. If omitted, the existing setting is not changed.name New LUN group name-volume-numberor-volume-nameOptional. This parameter specifies the volume identifiers to add a definition to the specifiedLUN group, and is paired with the "-lun" parameter. One or more parameters can be specifiedat the same time. If omitted, the existing setting is not changed. For details, refer to "1.2.10Volume Syntax" (page 26). If two or more LUNs are specified, these parameters must also bespecified in the same order as the associated volumes. Any already assigned definitionscannot be specified.Example:-volume-number 10-12 -lun 1-3-> The volume #10 and LUN 1 are pairs.-> The volume #11 and LUN 2 are pairs.-> The volume #12 and LUN 3 are pairs.-volume-name v1,v2 -lun 1-2-> The volume named "v1" and LUN 1 are pairs.-> The volume named "v2" and LUN 2 are pairs.volume_numbersVolume numbervolume_namesVolume name
