Chapter 7 NAS Function Setting and Display7.3 Network Interface Bonding > set nas-bondingETERNUS CLI User’s GuideCopyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0762set nas-bondingThis command configures NAS port bonding settings. Up to 15 member ports can be assigned to a singlemaster port.■ Syntax■ ParameterThis command is unavailable when firmware version V10L20 is being used.set nas-bonding -master-portport1 -member-portport2,port3,...[-mode {0|1|2|4|5|6}] [-hash-policy {L2|L23|L34}]-master-portThis parameter specifies the port that is to be set as the master port.• The following ports cannot be specified:- Ports other than the NAS port- Ports that are already specified as a member port- Ports with multipath settings• The settings of the NAS interface port that is assigned to the member port are retained.port1 Master portExample: -master-port 001-member-portThis parameter specifies the ports that are to be set as member ports. Multiple member portscan be specified by inserting a comma (,) between them as a delimiter.To add a member port, specify only the target port. If a port that has already been assigned toa member port of the target master port is specified, it does not cause an error.• The following ports cannot be specified:- Ports other than the NAS port- Ports that are specified as a master port- Ports that are specified as a member port for other master ports- Ports with multipath settings- Ports with different CMs from the master port• The settings of the NAS interface port that is assigned to the member port are deleted.