FUJITSU StorageETERNUS AF250 S2,ETERNUS AF250All-Flash ArraysOperation Guide (Basic)Operation management/maintenanceP3AG-1842-06ENZ0

Fujitsu ETERNUS AF250 S2 Basic Operation Manual

ETERNUS AF250

operation and maintenance

using this manual

compliance with standards

about this manual

symbols used in this manual

safety precautions

power synchronized unit

Chapter 1 Overview

Features

Specifications

Components

Table 1.2 Status and meanings of each LED (for power synchronized units)

AC Sensor Unit (Optional)

System Configuration

Figure 1.6 System configuration example (power synchronization with three or more server UPS units)

Power Management for Power Synchronization

Figure 1.8 Operation timing chart when using a power synchronized unit (powering on)

Figure 1.9 Power off using a power synchronized unit

Figure 1.10 Operation timing chart when using a power synchronized unit (powering off)

Chapter 2 Installation

Preparation

Installing in a Rack

Installing a Power Synchronized Unit

Installing an AC Sensor Unit

Chapter 3 Powering On and Off

Chapter 4 Connection and Settings

Setting the ETERNUS DX/AF

Figure 4.2 ETERNUS DX8700 S3/DX8900 S3 setup (Setup Power Management screen)

Figure 4.3 ETERNUS DX80 S2/DX90 S2 setup (Setup Power Management screen)

Figure 4.4 ETERNUS DX60 S2 setup (Setup Power Management screen)

Turning on the Power Synchronized Unit

Connecting Cascade Cables

Connecting to the Server UPS Unit

Connecting the Server UPS Unit to the Power Synchronized Unit

Connecting the AC Sensor Unit

Connecting to the ETERNUS DX/AF

Checking after Connection

Chapter 5 Adding a Connecting Device

Connection Procedure When Adding an ETERNUS DX/AF

Chapter 6 Operation and Maintenance

Replacing a Power Synchronized Unit

Troubleshooting

Trouble Record

Chapter 1 Component Names

Rear

Front

Power Distribution Units (for Regions other than the EMEIA, Central American, and Caribbean Re gions)

Figure 1.7 Power Distribution Unit (AC200-240V, 2U, 16 Outlets)

Chapter 2 Rack Installation

Power Distribution Unit Installation (for Regions other than the EMEIA, Central American, and Car ibbean Regions)

Installing Power Distribution Unit (1U)

Installing Power Distribution Unit (2U)

Controller Enclosure Installation (for Regions other than the EMEIA, Central American, and Carib bean Regions)

Drive Enclosure Installation (for Regions other than the EMEIA, Central American, and Caribbean Regions)

Chapter 3 Checking the Configuration Environment

server connection preparation

driver installation

iscsi initiator parameter settings

preparing the pc terminal for setup

lan connection preparation for operation management

lan related specifications

Chapter 4 Connecting Cables

Drive Enclosure Connection

power synchronized unit connection

When No Power Distribution Units Are Installed

When 1U Power Distribution Unit Is Installed (for Regions other than the EMEIA, Central American, and Carib bean Regions)

When 2U Power Distribution Unit Is Installed (for Regions other than the EMEIA, Central American, and Carib bean Regions)

Chapter 5 General Settings

Figure 5.1 Example of Differential Backup Settings with SnapOPC

Figure 5.2 Example of Creating Operation Volume and Backup Volume

pc terminal connection

Powering On

Switching On and Off the PSU Switch on the Power Supply Unit

eternus web gui startup

Storage Management (Initial Setup 1)

LAN Cable Connection (for Operation Management)

firewall settings

raid configuration settings

operation volume creation

Table 5.2 Operation Volume Creation

Generation Management Volume (SDV) Creation

Copy Data Destination Volume (SDPV) Creation

hot spare registration

Chapter 6 Monitoring Settings

various notification settings

E-mail Setup

syslog setup

remote support setup

Remote Support (by AIS Connect) Setup

Remote Support (by REMCS) Setup

audit log setup

Monitoring Server (SNMP Manager) Settings

transmission test execution

Send Test E-mail

Chapter 7 Power Control Setup

connection setup for power synchronized unit

Chapter 8 SAN Connection Settings

host affinity settings

ca reset group settings

server connection setup

lun recognition check

disk partition settings

Chapter 9 Advanced Copy Settings

copy table size settings

copy parameter settings

Performing a Copy (SnapOPC+)

Chapter 10 System Status Check

Checking the RAID Groups

Checking the Volumes

Checking the Copy Sessions

powering off

Chapter 11 Solution Configuration

Automatic Switching Operation of the Storage Systems (Storage Cluster)

Performance/Tuning

Virtualization Platform

vmware linkage

microsoft linkage

Security

Preface

Overview of Non-Stop Storage Solution

Protecting Investment and Optimizing Investment Cost

Example of a Non-Stop Storage Configuration

management server

Example of a Non-Stop Storage Configuration (with Redundant Management Servers)

Hardware Layout

Workflow for System Configuration

Conclusion

structure of this manual

naming conventions

operating environment

Chapter 1 Screen Operations

hardware components

Screen Structures

List Screen/Detailed Screen

Basic Operation

Chapter 2 System Status

System (Basic Information)

Network

Remote Support

support information

AIS Connect

Root Certificate

Key Management

Key Group

Define Role

Eco-mode

Eco-mode Schedule Detail

Event/Dump

Audit Log

Firmware Maintenance

Storage Migration

Path Group Detail Information

Utility

System Settings

Chapter 3 Component Status

Storage (Basic Information)

Controller Enclosure

Controller Module

Performance (CM)

Port Error Statistics (for the ETERNUS AF250 and the ETERNUS DX200F)

Channel Adapter

Performance (CA)

PCIe Flash Module

Performance (PCIe Flash Module)

Bootup and Utility Device

Power Supply Unit (CE)

Battery

Frontend Enclosure

Frontend Router

Power Supply Unit (FE)

FAN Unit

Operation Panel

Drive Enclosure

I/O Module

Port Error Statistics

Power Supply Unit (DE)

Fan Expander Module

Drives

Performance (Drive)

Drive Error Statistics

Controller Enclosure Detail

Controller Module Detail

Channel Adapter Detail

PCIe Flash Module Detail

PSU/CPSU (CE) Detail

Frontend Router Detail

Service Controller Detail

FE Power Supply Unit Detail

FAN Unit Detail

Drive Enclosure Detail

I/O Module Detail

Power Supply Unit (DE) Detail

Fan Expander Module Detail

Drive Detail

Bootup and Utility Device Detail

SAS Cable Detail

Frontend Cable Detail

Fujitsu ETERNUS AF250 S2 Basic Operation Manual

Product

Learn More

Legal