Epson C Series Maintenance Manual

Also see for C Series: Manual

C8 Maintenance 3. CoversC Series Maintenance Manual Rev.2 219C8-A701** (C8), C8-A901** (C8L)Installation(S, C models)Install the connector plate to the Manipulator.Hexagon socket head cap bolts: 11-M4×10Tightening Torque: 4.0 ± 0.2 N·mBe careful not to get the cables caught between the cover and the Manipulator.C8-A701** (C8), C8-A901** (C8L)Installation(P model)1. Install the spacers to the holes on the gasket.(11 places)2. Apply the liquid gasket to the base rear gasket.Install the base rear gasket to the connector plate.(See the figure for gasket applying points)Base rear gasketGasketApplyingpoint (×11)Spacer (×11)Connector plateAfter applying the liquid gasket, leave the gasket until the liquid gasket becomes solidand the gasket is fixed.3. Install the connector plate to the Manipulator.Hexagon socket head cap bolts: 11-M4×10Tightening torque: 4.0 ± 0.2 N·mBe careful not to get the gasket and cables caught between the cover and theManipulator.Replace the gasket if there are flaws or deteriorations.NOTENOTE