Electrolux Next Gen 30" Service Manual

Also see for 30" GAS FREESTANDING RANGES: Installation instructions Service update manual

Contents

32G. Connect Electricity to Gas RangeElectrical Requirements120 volt, 60 Hertz, individual, properly grounded andpolarized branch circuit protected by a 15 amp. cir-cuit breaker or time delay fuse.Extension Cord Cautions:Because of potential safety hazards under certainconditions we strongly recommend against the useof any extension cord. However, if you still select touse an extension cord, it is absolutely necessarythat it be a UL listed 3-Wire grounding type appli-ance extension cord and that the current carryingrating of the cord in amperes be equivalent to orgreater than the branch circuit rating. Such exten-sion cords are obtainable through your local ser-vice organization.Grounding InstructionsIMPORTANT Please read carefully.For personal safety, this appliance must beproperly grounded.The power cord of this appliance is equipped with a3-prong (grounding) plug which mates with a stan-dard 3-prong grounding wall receptacle (see Figure16) to minimize the possibility of electric shock haz-ard from the appliance.The wall receptacle and circuit should be checkedby a qualified electrician to make sure the recep-tacle is properly grounded.Where a standard 2-prong wall receptacle is in-stalled, it is the personal responsibility and obliga-tion of the consumer to have it replaced by a prop-erly grounded 3-prong wall receptacle.Do not, under any circumstances,cut or remove the third (ground) prong from thepower cord.Disconnect electrical supply cord from wall recep-tacle before servicing range.H. Check OperationRefer to the Use and Care Guide packaged with therange for operating instructions and for care andcleaning of your range.Do not touch the burners. They may be hot enoughto cause burns.1. Check the ignitersOperation of electric igniters should be checked af-ter range and supply line connectors have beencarefully checked for leaks and range has beenconnected to electric power.Note: If range is to be operated on L.P. gas, con-version of regulator and adjustment of burnerspuds is necessary before ignition check.a) Surface Burner IgnitersTo check for proper lighting, push in and turn asurface burner knob to the LITE position. Thesurface burner should light when gas is avail-able to top burner. Each burner should lightwithin 4 seconds in normal operation after airhas been purged from supply lines. Once theburner lights, knob should be rotated out of theLITE position. Try each valve separately untilall burners have been checked out.b) Oven Igniter SystemSelf-Clean Models - Remove all materials and lit-erature from oven and:1. Push the BAKE TEMP button and set theoven temperature to 300°F. Within 60 sec-onds the bake (lower) burner will ignite.Check for proper flame; push the CANCELbutton.2. Push the broil button and set the oven tem-perature to 300°F. Within 60 seconds thebroil (upper) burner will ignite. Check forproper flame. Allow burners to cycle at leastone time; push the CANCEL button.Figure 16Preferred Method Do not, under anycircumstances,cut, remove, orbypass thegrounding prong.Power supply cord with3-prong grounding plugGroundingtype wallreceptacle