Electrolux Next Gen 30" Service Manual

Also see for 30" GAS FREESTANDING RANGES: Installation instructions Service update manual

Contents

110Tennamen nutRemoving bodyside panels:1. Disconnect power and remove the back of the controlpanel and the back cover.2. Place a rug or padding under the range to protectthe floor.3. Remove the backguard end cap on the side of therange that the bodyside is being removed.4. Remove the oven door and drawer.6. Remove five screws holding the bodyside panel tothe back of the range.Bodyside back screws6. Remove one screw in the back holding thebodyside panel to bottom rail.7. Remove five screws from the front. It is not necessaryto remove the two short screws holding the heatshield in the upper corner, but you do need to transferthis to the replacement panel if the panel is beingreplaced.Bodyside bottom rail screwBodyside front screws8. Remove the top locating pin and the two screwsholding the bodyside to the burner pan.Bodyside top screws and pin9. With one hand in the oven and the other in the backlift the side of the range with the bodyside you areremoving. Slide the bodyside down and the bottomof the panel out.