Electrolux 6000 Service Manual

Also see for 7000: User manual Service manual Instruction book Manual User manual

Contents

8FUNCTION TEST SEQUENCE1. Press and hold Select and Cancel buttons simultaneously for 6 seconds to reset the control. The buzzer willsound 1 time and “rES” will be shown briefly in the display.2. Immediately after, rotate cycle selector knob 5 turns counterclockwise to the second position from the bottom.Press and hold the Options and Cancel buttons simultaneously for 2 seconds. The control will enter testmode, the buzzer will sound 3 times and all LED’s will rapidly flash.After entering the test mode, the cycle selector knob can now be rotated to select the following tests:Rotate the cycle selector knob clockwise from the starting position:0 turns: All LED’s will flash.1 turn: Drive motor runs; heat source is on. Drying LED is lit. “H” and the control thermistor reading willtoggle back and forth in the display.2 turns: Drive motor runs; heat source is off. Cool Down LED is lit and “AF” (Air Fluff) is displayed.3 turns: Drive motor runs; heat source is off. Drying and Cool Down LED’s are lit and numbers appear inthe display showing moisture sensor readings. Opening the door (press in on door switch plunger)and placing a finger on the both moisture sense bars at the same time will make the numbersdecrease. In controls that do not have a digit display, the More Dry LED should be ON. Openingthe door (press in on door switch plunger) and placing a finger on the both moisture sense bars atthe same time will make the Damp LED come on.4 turns: Drive motor runs; heat source is off.Key test:a. When the Temperature key is pressed, all the temperature LED’s should light.b. When the Dryness key is pressed, all the dryness level LED’s should light.c. When the Options or Select key is pressed, all the Option LED’s should light.d. When the Start/Pause key is pressed, all the cycle status LED’s should light.e. When the Cancel key is pressed, all the cycle status LED’s should light.5 turns: Drive motor runs; heat source is off. Cool Down LED is lit. Control thermistor reading isdisplayed.6 turns: Drive motor runs; heat source is on. Drying LED is lit. Control thermistor reading is displayed.7-11 turns: All LED’s will flash.To EXIT test mode, press and hold the Select and Cancel buttons simultaneously for 6 seconds or disconnectpower from dryer. Dryer will be reset for regular operation.