223. Place items to be dried on top of the rack. Weightshould not exceed 10 lbs. Leave space betweenitems, but do not let items hang over the sides orthrough the grids. Do not tumble other items whenusing the drying rack.4. Select a timed dry. Use only the Air Fluff (no heat)temperature setting for items containing plastic,foam rubber, rubber-like materials, feathers or down.5. When items are dry, remove the rack and replace thelint screen. If lint screen is not in place, tumblingitems could enter the exhaust system and causedamage to the dryer.• If desired, add a dryer fabric softener sheet.4. Close the dryer door and select the cycle,temperature,dryness level and options desired.See Operating Instructions card for your specificmodel information.5. Press START to begin the cycle.• To add or remove items when the dryer isrunning open the door. The dryer will stop whenthe door is opened. Allow the drum to come to acomplete stop before reaching inside.• Close the door and press START to resume thecycle.6. When the cycle ends, remove items immediatelyand hang or fold.FeaturesEnd of Cycle SignalA signal will sound at the end of the cycle and periodicallyduring Press Saver at the volume level selected. (Somemodels)Drum Light (some models)A drum light will come on whenever the door is openedto illuminate the dryer drum during loading andunloading. Closing the door turns off the light.Reversible Dryer DoorYour dryer is equipped with a reversible door. The doorcan be hinged on the right or left side. Refer to theINSTALLATION INSTRUCTIONS for directions onchanging the door.Drying Rack (some models)Use the drying rack to dry items which should not betumble dried.1. Open the dryer door and remove the lint screen.2. Insert drying rack into the dryer drum. Place thefront bar under the lip of the lint screen opening.