Electrolux 6000 Service Manual

Also see for 7000: User manual Service manual Instruction book Manual User manual

Contents

378. Tighten the strain relief nut securely so that the strainrelief does not turn.9. Reinstall the terminal block cover.This dryer is equipped with a three-prong (grounding)plug for your protection against shock hazard and shouldbe plugged directly into a properly grounded three-prongreceptacle. Do not cut or remove the grounding prongfrom this plug.ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEMNON-CANADIAN ELECTRIC Dryer1. Remove the screws securing the terminal blockaccess cover and the strain relief mounting bracketlocated on the back of the dryer upper corner.2. Install a U.L. approved strain relief in the entry hole ofthe mounting bracket. Finger tighten the nut only atthis time.1. The dryer must be grounded. In the event of amalfunction or breakdown, grounding will reduce therisk of electrical shock by a path of least resistancefor electrical current.2. Since your dryer is equipped with a power supplycord having an equipment-grounding conductor anda grounding plug, the plug must be plugged into anappropriate outlet that is properly installed andgrounded in accordance with all local codes andordinances. If in doubt, call a licensed electrician.Do not modify plug provided with the appliance.ALL GAS DryersThis dryer is equipped with a three-prong (grounding plugfor your protection against shock hazard and should beplugged directly into a properly grounded three-prongreceptacle. Do not cut or remove the grounding prongfrom this plug.ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEMNON-CANADIAN ELECTRIC Dryer1. Remove the screws securing the terminal blockaccess cover and the strain relief mounting bracketlocated on the back of the dryer upper corner.2. Install a U.L. approved strain relief into the power cordentry hole of the mounting bracket. Finger tightenthe nut only at this time.3. Thread a U.L. approved 30 amp. power cord, NEMA10-30 type SRDT, through the strain relief.4. Attach the power cord neutral (center wire) conductorto the silver colored center terminal on the terminalblock. Tighten the screw securely.5. Attach the remaining two power cord outer conductorsto the outer brass colored terminals on the terminalblock. Tighten both screws securely.Do not make a sharp bend or crimpwiring/conductor at connections.6. Reattach the strain relief mounting bracket to the backof the dryer with two screws. Tighten screwssecurely.7. Tighten the screws securing the cord restraint firmlyagainst the power cord.POWERCORDTIGHTENNUTTO THESETHREADSSTRAINRELIEFMOUNTINGBRACKETGREENGROUNDSCREWNUTSILVER TERMINALGREENNEUTRALGROUNDWIRE