Dacor Renaissance ER30D Planning Manual

Also see for ER30D: Instruction manual Technical manual Installation instructions Use and care manual Installation instructions

Dacor Renaissance ER30D Planning Manual Manual pdf 1 page image

All specifications subject to change without notice. Phone: (800) 793-0093www.dacor.comPLANNINGGUIDEER30D, ER30DSRRenaissance® 30” WideDual Fuel RangesDocument # PG05-003 Revised 10/22/14 Page 1/3ELECTRIC CIRCUIT REQUIREMENTSRange Model Circuit Required Total ConnectedLoadER30D/ER30DSR 240 Vac, 4-wire*60 Hz, 30 Amp. 5.6 kW (24.2 Amp.)◊ The ratings above are for reference only - refer to the range ratinglabel.◊ Model ER30D-C is a freestanding range that comes with a factoryinstalled 4-wire appliance cord and NEMA 14-50P plug. This wiringconfiguration is required for freestanding ranges installed in Canada,although they may be used elsewhere, if local codes permit. The plugis designed to plug directly into a NEMA 14-50R electrical receptacleinstalled by a licensed electrician according to specifications. Do notmodify the factory wiring on model ER30D-C.NOTE: Models ER30D and ER30D-C are NOT designed foruse with self-rimming installations or downdraft vents.Use model ER30DSR for self-rimming and downdraft ventinstallations.NOTE:■ Self-rimming models are designed to allow the trim tooverlap the countertop when configured to the dimensionsshown on page 3/3.■ Self-rimming models are not compatible with integralbackguards.1 9/16”(4.0 cm)23 1/8” (58.7 cm)24 1/8” (61.3 cm)27 3/16” (69.1 cm)35 3/4”(90.8 cm)to37 7/8”(96.2 cm)28 11/16” (72.9 cm)46 1/8” (117.2 cm)Rear of front panel toback of chassisRear of front panel /oven doorFront panelFront edge of bullnoseFront of handleFront of open door26 3/16” (66.5 cm)Width at front panel:29 7/8” (75.8 cm)1 5/16” (3.3 cm) to cookingsurface (top of grates) frombottom of trimSELF RIMMING MODEL ER30DSRSIDE DIMENSIONSWITH OPTIONAL DOWNDRAFT VENTTRIM KIT INSTALLED (ATK30SR)1 1/16” (2.7 cm)26 5/16” (66.8 cm)27 5/16” (69.4 cm)28 13/16” (73.2 cm)24 1/4” (61.6 cm)3” (7.6 cm)Backguard*6” (15.2 cm)Backguard**** OptionalStandard*37 7/8”(96.2 cm)to35 3/4”(90.8 cm)46 1/4” (117.5 cm)Width at front panel:29 7/8” (75.8 cm)Finished side panel1 9/16”(4.0 cm) 1 1/16” (2.7 cm) to cookingsurface (top of grates) fromtop of trimFREESTANDING MODELS ER30D AND ER30D-C 1 9/16”(4.0 cm)23 1/8” (58.7 cm)23 5/8” (60.0 cm)26 11/16” (67.8 cm)35 3/4”(90.8 cm)to37 7/8”(96.2 cm)28 3/16” (71.6 cm)45 5/8” (115.9 cm)Rear of front panel toback of chassisRear of front panel /oven doorFront panelFront edge of bullnoseFront of handleFront of open door25 11/16” (65.2 cm)Width at front panel:29 7/8” (75.8 cm)1 5/16” (3.3 cm) to cookingsurface (top of grates) frombottom of trimSELF RIMMING MODEL ER30DSRSIDE DIMENSIONSWITH STANDARD TRIMProduct tolerances: ±1/16” (±1.6 mm) unless otherwise statedWARNING• Observe all governing codes and ordinances duringplanning and installation. Contact your local buildingdepartment for further information.• This appliance must be installed in accordance withthe accompanying installation instructions.* 4-wire, two 120 Vac hot (L1 and L2), one neutral, one ground

/ 3

Related manuals for Dacor ER30D