7Before You Call for ServiceProblem Solution GuidePrOBLEM MAY BE CAuSED BY WHAT TO DOnothing works. power plug disconnected. Connect plug to a dedicated, grounded, three-prong electrical outlet.timer is not set. Select time duration according to theOperating Instructions section.Warming drawer is not connectedto power.plug the warming drawer into a 120 vac,15 amp, dedicated electrical outlet.tripped circuit breaker or blownfuse.Check the house circuit breaker or fuse forthe circuit that supplies power to the warmingdrawer.Drawer does not slide smoothlyor drags.Drawer is incorrectly mounted intoslide mechanism.remount drawer into slide, per instructionsabove.Drawer is over-loaded or the loadis unbalanced.reduce the weight to less than 50 pounds.redistribute drawer contents.excessive condensation. Warming drawer not preheated. preheat the warming drawer before each use.Incorrect humidity control setting. Set humidity control to CrIsP to allow mois-ture to vent.One or more of the indica-tor lights on the control panelflashes on and off.the control panel computer hasdetected an error.try resetting the computer. Disconnect thepower cord, wait 20 seconds, then reconnectit. Check the control panel. If the indicatorlight still flashes, call the Dacor CustomerService team at (800) 793-0093.Care and CleaningDrawer Installationpush in on tab.Drawer removalpull up ondrawer front.push drawer frontdown until tab locksin place.Slide mounting bracketunder clip on slide.Clip on slideSlide