12Installation InstructionsVerifying Proper OperationWARNING• Read the raised vent use and care manual completelybefore operation.• Install all of the front filters prior to operating the raisedvent. Refer to the use and care manual for filter instal-lation instructions.CAUTIONTo prevent damage to the raised vent power cord, routeit away from the surfaces of the range or cooktop beforeconnecting it.1. Make sure the power switch on the top of the raisedvent is in the up position.2. Plug the raised vent power plug into the electrical out-let.3. Press the power switch once to raise the vent to itsoperating position.4. Once in the up position the vent should begin to drawair. Turn the variable speed control switch in both direc-tions to verify that the system is operating correctly.5. Press the top cap up/down switch once to lower thevent.6. Make sure that the top cap on the raised vent intakedoes not catch on the back edge of the cooktop orrange when the intake is lowered. If interferenceoccurs, adjust the position of the cooktop or range.Failure to eliminate any interference may result in per-manent damage to the vent.If the raised vent is not operational after installation:• Make sure that power is being supplied to the unit.• Make sure that power is being supplied to the blowerfrom the raised vent.• If the vent will not raise properly or makes a scrapingsound check for obstructions interfering with the raisingof the unit.If the raised vent still does not function after performing theabove checks, do not attempt to repair it yourself. ContactDacor Distinctive Service at (877) 337-3226. Be sure tohave all model and serial numbers from the product datalabels for the raised vent and the blower available whenyou call.Dacor is not responsible for the cost of correcting problemscaused by a faulty installation.Installation Checklist□ Are the anchor legs extended down to make contactwith the floor and tightened into place? Are the anchorlegs fastened to the floor? Is the unit level?□ Is the duct work completely installed? Are all jointsattached with sheet metal screws and wrapped withduct tape?□ Are both ends of the remote or in-line blower powercable connected (to the raised vent and to the bloweritself)?□ Are the vent filters installed according to the use andcare manual instructions?□ Is the power cord routed away from the hot surfaces ofthe range or cooktop.□ Is the unit connected to an electrical outlet that meetsthe electrical specifications in these instructions?□ Has proper operation been verified?□ Has the warranty been activated on-line or the warrantycard been filled out completely and mailed?