D-Link DWC-1000 User Manual133Section 4 - Advanced WLAN ConfigurationAfter the download begins, the AP Firmware Status tab will display information about the upgrade. Refer to thetable below:Field DescriptionCode Download StatusStatus (Global)The status of the upgrade process for all APs:• Not Started: The wireless controller has not started the download process.• Requested: A request to download AP software has been made, but the controllerhas not done any downloads.• Code Transfer in Progress: A download is in progress.• Failure: Download failed on all APs.• Aborted: Download was aborted before the AP loaded code from the TFTP server.• NVRAM‐Update‐in‐Progress: Download completed successfully. The resetcommand has been sent to the AP.• Success: All APs are connected to the wireless controller.Download CountThe number of managed APs to download software in the current download request.If you selected All for the managed APs to upgrade, the download count shows thenumber of managed APs at the time the download request was started. The value is 1if only one AP is being updated.Success CountThe number of APs that have successfully downloaded the new code. This valuestarts with 0 at the beginning of the download and increases by one for every AP thatsuccessfully downloaded the code.Failure Count The number of APs that failed to download the new code starting at 0 and incrementingwith each failure.Abort Count The number of APs for which the download was aborted, starting at 0 and incrementingeach aborted download.Path: Maintenance > Firmware > AP Firmware Download > AP Firmware StatusAP Firmware Status
