D-Link DWC-1000 User Manual101Section 4 - Advanced WLAN ConfigurationManual Change Channel and Power of Managed APPath: Wireless > Access Point > Managed APs List > Managed APsFrom the Managed AP page, you can also manually change the RF channel and power for each radio on an AP.The manual power and channel changes override the settings configured in the AP profile (including automaticchannel selection) and take effect immediately. The manual channel and power assignments are not retainedwhen the AP is reset or if the profile is reapplied to the AP, such as when the AP disassociates and re-associateswith the controller.1. Click Wireless > Access Point > Managed APs List > Managed APs tab.3. Select the channel as your desired. The available channels depend on the radio mode and country inwhich the APs operate. The manual channel change overrides the channel configured in the AP profileand is not retained when the AP reboots or when the AP profile is reapplied.4. Change the power as your desired. You can set a new power level for the AP. The manual power changeoverrides the power setting configured in the AP profile and is not retained when the AP reboots orwhen the AP profile is reapplied.5. Click Save.2. Right-click on one of the entries, and select Channel and Power.
