Menu
Craftsman SECURITY + 139.53684 User Manual
  | |
Contents |
FeaturesFor use with any SECURITY: compatiblegarage door opener receiver.Personalized Password: Up to 10,000possible combinations. Password can be easilychanged if desired.Temporary password: Can be added for visitors or servicepersons. This temporary password can be limited to a programmablenumber of hours or a programmable number of entries.Rolling Code: While your password remains constant until youchange it, the code between the Keyless Entry and the receiverchanges with each use, randomly accessing over 100 billion newcodes.Operation: Opener activates when 4-digit password and Enter buttonis pressed.If wrong numbers are accidentally pressed, correction can be madeimmediately. The Enter button will transmit only the last four digits.The Keypad will blink for 15 seconds after the password istransmitted. During that time the Enter button can be used to stop orreverse the door travel.The Lock feature on openers with premium door controls is designedto prevent operation of the door from portable transmitters.However, the door will open and close from the door control pushbutton and the Keyless Entry.To comply with FCC rules, adjustment or modification of receiver and/ortransmitter is prohibited, except for changing the password setting and replacingthe transmitter battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.InstallationThe recommendedmounting locations forsectional and one-piecedoors are shown inFigure 3. You can selectanother location if youprefer. However, thekeypadmust beinstalled within sight ofthe door.For a one-piece door,use the optional location shown in theillustration (on theedge of the door jamb) to avoid injuryas the door swings up and out.Test the reception of the Keyless Entry by operating youropener from the selected location. Change the location ifnecessary.Open the keypad and remove thebattery compartment screw andcover to access the bottommounting hole(Figure 4).Center the keypad at eye levelagainst the selected location. Mark4 1/4" up the centerline from thebottom and drill a 1/8" pilot hole.Install top mounting screw, allowing1/8" to protrude above surface.Position keypad on screw head andadjust for snug fit.With cover open so bottommounting hole is visible, use a punch tomark hole. Remove keypad and drill 1/8" pilot hole. Replacekeypad and complete installation with bottom screw, usingcare to avoid cracking plastic housing.Do not overtighten.Replace the battery cover.Side two contains instructions for changing the personalentry password and setting a temporary password.Door Jamb Edge(Optional Locationfor 1-Piece Door)KeypadDoor Jamb FaceSECTIONAL DOOR ONLYKEYPAD MUST BE INSTALLEDWITHIN SIGHT OF THE DOORExterior Front Wall1-Piece orSectional DoorClavierLE CLAVIER DOIT ÊTRE POSÉ DE FAÇONQUE LA PORTE SOIT VISIBLE DU CLAVIERMur avant extérieurPorte rigide ou articuléeBordure étroitedu montant de porte(emplacement en optionpour les portes rigides)Face du montantPORTE ARTICULÉE SEULEMENTSetting the Personal Entry PasswordWe recommend that you program your password now, beforeyou install the Keyless Entry. Then you can test the receptionat the mounting location before you proceed further.Choose a 4-digit password using the numbers from 0 to 9 (anumber can be used more than once, for example, 4,0, 4,1.)If you have a Premium Control Console:1. With the door closed, press the four buttons forthe password, then press andhold Enter.2. Press and hold the light button on the doorcontrol,Figure 1.3. Press and hold the door control push button.4. After the opener light flashes, release allbuttons.If you do not have a Premium Control Console:1. Enter the four digit password desired, then press andholdEnter.2. Press and release the SRT (learn) button on the dooropener panel,Figure 2.3. After the opener light flashes, release the Enter button.Test by pressing your password, then press Enter. The doorshould begin to move.This procedure can be repeated with a different password foruse with a second garage door opener.The Chamberlain Group, Inc.Digital Keyless EntryReplace Battery7/18/95 - 7/29/96BatteryBottommounting holeBatteryCoverKeypadCoverSECURITY: Garage Door OpenerKG KG13975139751 2 3OrangeSRT (learn)ButtonYellowIndicatorLightChildren operating or playing with a garage door opener caninjure themselves or others.The garage door could close andcause serious injury or death. Do not allow children to operate thewall push button(s) or remote control(s).A moving garage door could injure or kill someone under it.Activate the opener only when you can see the door clearly, it isfree of obstructions, and is properly adjusted.WARNINGCAUTIONAVERTISSEMENTATTENTION1® Model 139.53684Keyless EntryFigure 2Figure 1Figure 3Figure 4The Chamberlain Group, Inc.3 Button Wall ControlFront View5/1/95LOCKLIGHTLightDoor ControlPush buttonSecurity:Garage Door Opener |
Related manuals for Craftsman SECURITY + 139.53684
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved