Craftsman 695.65796 Owner's Manual

Figure 5 Adjusting Jaw to AngleFront Jaw adjusts to a maximum angle of 9 degrees forolamplng Irregular shaped workplsces. To adjust jaw toangle, turn either the right or left adjustment handle untildesired angle is reached. (See Figure 7.)Figure 7Jaw Use and AdjustmentYour CRAFTSMAN ® Clamping Table ls designed formaximum versatility.The Tabte top jaws adjust to clampmany workplace sizes or shapes to simplify sawing,planing, sanding, drilling, routing, gluing and paintingjobs,Fi_lure 6DO NOT attempt to use your OlampingTable unless the Jaws are securelylocked in position,To Adjust Table Top JawTurn the 2 front table top jaw adjustment handlescounterotockwiseto move front jaw out; turn adjustmenthandles clockwise to move front Jaw In_(See Figure 6.)The table top Jaw opens to clamp a maximum 4-1nobwide workpfece.Using Adjustable Swivel Pegs to HoldIrregular Shaped WorkpieoesYour Olamplng Table Is equipped with 4 swivel pegs.The swivel pegs can be posltloned into any of the holesIn theJaws and rear of top for gripping frregular shapedworkpleces, or to extend gripping and clamping whenyour workplaceexceeds _hajaw capacity, (see F3gure8.)1. Fully extend fmntJaw.2. Place workplace on stand top.3. Push sw]ve] pegs into appropr]ate holes tn table topand tighten jaw to securely grip workplace. (SeeFigure8.)Figure 8Increasing Gripping and Clamping CapacityIf workplaceexceedsJaw capacity,reposltlonswivel pegsInto hole Inthe back row of holes tn tabletop.(See Rgure9.)