Craftsman 695.65796 Owner's Manual

TheCRAFTSMAN e Clamplng Table provides a worksurface of up to 40-3/4 '_.It features a largo 30" x 20-1/2"ti(ting top made of durable _B/4-1nchthlak MDF (MediumDenslty Fiber). Its steel frame supports up to 330 Ibs,,and thero ]s a convenient storage rack with slots fortable pegs, parts and for hand toofs, such asscrewdrivers and chisels. Jaw Is adjustable up to 9degrees for holding Irregularly-shaped workpleoes.A step bar provldes additional support and stability,The major components of your dRAFTSMAN ®Clamping Table have been assembled at 1he factory.This lnctudes the table top, the support posts, and tholegs, You need to complete _he shop stand by assem-bling the following components to each other."= table top to support posts= short locking handles to support posts= feet to Iegs• long locking handles to Ieg_= table top/support posts to logsFor these proaedures, you need a #3 Phillipsscrewdriver and an adjustable-head wrench.Table Top to Support Posts1. Place stand top (A) upside.down on a smoothsurface. (See Ftgura 2,)Figure 22. With vlangular-shapod tilt brackets on Inside of railand pivoted toward rear of table, attach _upportposts assembly (D) with 4 bolts (H) and 4 nuts (N),2 on each side,3. Tighten with Phillips screwdriver and adjustable-head wrench.Looklng Handles to Support Posts1, Move support posts assembly (D) to mostadvanced position (small tabs Ilmlt movement).(See Figure 2.)2. Maintaining a_embly In most advanced posltlonwith your shoulder, place tabs of nut holder (F)(over nut [I_]) and Into slots. White holding nutholder In slot with nut, use other hand to threadshort looking handle (B) Into nut3. Repeat for other side.To tighten: Turn handles clockwise.To loosen: Turn handles counterclockwise.BDNFD FHA4