Craftsman 247.77013.0 Operator's Manual

Also see for 247.77013.0: Operator's manual Operator's manual Operator's manual Parts list Parts list

Contents

ASSEMBLYFigure 2Figure 3Figure 4aTTaCHing THe HanDLe1. Remove the hairpin clips from the handle brackets and remove thecarriage screws and wing nuts from the lower handle.a. Place the bottom holes in lower handle over the pins on thehandle brackets and secure with hairpin clips. See Figure 2.b. Insert carriage screws through upper hole in lower handle fromthe inside and secure with wing nuts. See Figure 2.2. a. Unfold the upper handle until it aligns with lower handle. Makesure the rope guide is on the right side of upper handle. SeeFigure 3.IMPORTANT: Make sure the cables are routed outside the lowerhandle. Also, do not crimp the cables while lifting up the handles.b. Secure the two handles by tightening the handle knobs (carriagebolts must be seated properly into the handle). See Figure 3.3. Pull the two cable ties attached to the cables tight approximately8 inches from each cable end and place the cables into the cableguide.4. Loosen the wing nut that secures the rope guide to the right side ofupper handle.a. Pull the starter rope out of the engine slowly. See Figure 4.b. Slip the starter rope into the rope guide. Tighten the wing nut.See Figure 4.Rope GuideABAB