Craftsman 161.210400 Owner's Manual

vage ZbOn 1975 and later Ford electronic ignition systems, connect the GREENcllp from the Craftsman Engine Analyzer to the wire terminal on the TACHside of the coll as shown in FIGURE 3_ below.Connect the RED clip to the positive battery terminal and the BLACK cllpto a clean and secure ground such as the engine block,GREENFIGURE 30DWELL CONNECTION TOi975 AND LATER FORDELECTRONIC IGNITIONSYSTEMSOn General Motors cars equipped with an ENGINE ELECTRICAL DIAGNOSTICCONNECTOR (usually located under the hood near the left front fenderwheel well), open the hinged cover and insert the spade terminal adapterin socket number 6, as shown in Figure31, below. Connect the GREEN clipfrom the Craftsman Engine Analyzer to the spade teHminal adapter Justinstalled, Connect the RED cllp to the posltive battery terminal and theBLACK cllp to a clean and secure ground such as the engine block.NOTE: Experience has shown that this is the easiest way to make a dwellconnection to GM vehicles. Only if your vehicle does not have an ENGINEELECTRICAL DIAGNOSTIC CONNECTOR should you use one of the two (2) connectionprocedures to follow.CAUTION: Do not confuse the ENGINE ELECTRICAL DIAGNOSTIC CONNECTOR withthe HEATER/AIR CONDITIONING DIAGNOSTIC CONNECTOR located on the passengerside of the vehicle near the air conditioning system.DWELL CONNECTION TOGENERAL MOTORS CARSWITH DELCO HEI ANDDIAGNOSTIC CONNECTOR,ELECTRICALDIAGNOSTICCONNECTORTERMINAL ELECTRICALDIAGNOSTICCONNECTORFIGURE 31