Craftsman 125.12007 Operator's Manual

Also see for 125.12007: Operator's manual

6Assembly (continued)A Phillps head screw driver is required.WARNING: Do not plug in powercord to power outlet, make sureplug is disconnected beforeassembling the wet/dry vac.!1 4 52 3108 976a 6b 6c 6dUNPACKING YOUR WET/DRYVACUUM & GENERAL ASSEMBLY1. Verify that the power cord isdisconnected from the outlet.(Fig. 1)2. Undo the latches. (Fig. 2)3. Lift the power head off the collectiontank and place on a flat cleansurface. (Fig. 3)4. Remove the contents from inside thecollection tank, make sure you haveall contents as listed on cartoncontent list on page 5. (Fig. 4)5. With the power head removed, turnthe collection tank upside down.Insert the four caster assembliesinto each socket. Apply pressureuntil caster assemblies fully seated.(Fig. 5) Secure them with the screwsprovided. Do not over tighten thescrews.6. Position the hose storage rackas illustrated. Fully insert one endof the hose storage rack into theslot illustrated buy the arrow, thenpull the other end of the hosestorage rack to align with thecorresponding arrow and insert intothe slot until it is secured in place.(Fig. 6a - Fig. 6d)7. Place the power head back on thecollection tank, and secure intoplace using the 2 side latches. (Fig.7 & Fig. 8)8. Insert the locking end of the hoseinto the port on the collection tankand turn to lock in to place. (Fig. 9)9. Choose the desired accessory andinsert onto the end of the hose(Fig. 10)10. After vac use, store hose,accessories and cord as illustratedon page 12.