Craftsman 113.170250 Owner's Manual

Contents

Filter Assembly1. Carefully slide the filter over the filtercage, sliding it over the center ring cov-ering the 3 slots until the filter stopsagainst the lid.2. Place the hole in the filter plate overthreaded screw of the filter cage.3. Gently push on the filter plate to seatthe rubber ring of the filter inside the cir-cular channel of the filter plate.4. Place filter nut onto threaded screw andtighten it down. Finger tighten only.NOTE: Lever of filter nut should be awayfrom plate as shown.IMPORTANT: Do not overtighten as thismay deform or crack the filter plate, filtercage or the filter.NOTE: Your filter has a red stripe thatmatches an in-store disptayer. When youvisit your local Sears store, just rememberthe color of your stripe for the correct sizefilter.Vac Assembly1. Locate the lid assembly and the drum/caddy assemblies (assembled earlier).2. Position the lid assembly with the inletof the unit located in line with the draincap and the drum label on the vac.Allow the assembly to rest on the vacdrum.3. Rotate both latches down until you hearthe latches snap over the lip of thedrum.NOTE: For best appearance of the unit,the inlet of the vac should be locatedabove the drain.Cord StorageSimply wrap the power cord around the lidassembly and snap the connector on theplug to a wrap of the cord.Latch Latch