Craftsman 11145 Owner's Manual

RULES FOR SAFE OPERATION (CONTINUED)!4,. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see thdtkeys and adjusting wrenches are removed from tool before turning it on,15. NEVER USE IN AN EXPLOSIVE ATMOSPHERE_ Normat sparking of the motor couldignite flammable liquids, gases or fumes,t6 KEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use aclean cloth when cleaning.. Never use brake fluids, gasoline, petroleum_basedproducts, or any strong solvents to clean your tool,17. STAY ALERT. Watch what you are doing and use common sense, Do not operatetool when you are tired. Do not rush°t8. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part thatis damaged should be carefully checked to determine that it will operate properlyand perform its intended function. Check for alignment of moving parts, binding ofmoving parts, breakage of parts, mounting, and any other conditions that may affectits operation. A guard or other part that is damaged should be properly repaired orreplaced by an authorized service center,19, DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF, Have defectiveswitches replaced by authorized service center°20, DRUGS, ALCOHOL, MEDICATION. Do not operate _ooI while under the influence ofdrugs, alcohol, or any medication_21. CUTTING, DRILLING, OR DRIVING SCREWS INTO ELECTRICAL WIRING INWALLS, CEILINGS, OR OTHER AREAS CAN CAUSE BLADE, BIT, OR CHUCK TOBECOME ELECTRICALLY LIVED Grasp only the insulated handle(s) or plastichousing when using the tool22 WEAR HEARING PROTECTION DURING EXTENDED PERIODS OF OPERATION°IMPORTANT SAFETY RULES FOR BATTERY TOOLS23 Battery tools do not have to be plugged into an electrical outlet, therefore they arealways in operating condition., Be aware of possible hazards when not using yourbattery tool or when changing accessories°24. USE ONLY THE CHARGER PROVIDED WITH YOUR BATTERY TOOL. Do notsubstitute any other charger. Use of another charger could cause batteries to ex-plode causing possible serious injury.25 DO NOT PLACE BATTERY TOOLS OR THEIR BATTERIES NEAR FIRE OR HEAT.They may explode°26 DO NOT CHARGE BATTERY TOOL IN A DAMP OR WET LOCATION°27. Your battery tool shoutd be charged in a location where the temperature is morethan 50°F but less than 100"F.28 Under extreme usage or temperature conditions, battery leakage may occur, if liquidcomes in contact with your skin, wash immediately with soap and water, thenneutralize with lemon juice or vinegar. If liquid gets in your eyes, flush them withclean water for at _east 10 minutes, then seek immediate medical attention.29, If carrying your battery tool at your side, make sure it is not running and your fingeris not on the switch, Avoid accidental starting.30 SECURE WORK before applying power. NEVER hold workpiece in your hand oracross your legs.31, SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instructthird party user° If you loan someone this tool, loan them these instructions also_Page 3