Craftsman 107.16575 Owner's Manual

Also see for 107.16574: Owner's manual

A •EXTENSION CORDSNOTE: Avoid use of extension cords.1. For optimum performance, plug the compressor power corddirectly into a grounded wall socket. Do not use an extensioncord unless absolutely necessary. Instead, use a longer airhose to reach the area where the air is needed.2. If use of an extension cord cannot be avoided, the cord shouldbe no longer than 50 feet and be a minimum wire size of 12gauge (AWG). Do not use a 16 or 14 gauge extension cord.3. Use only a 3-wire extension cord that has a 3-blade groundingplug, and a 3-slot receptacle that wilt accept the plug on theproduct. Make sure your extension cord is in good condition.An undersized cord wilt cause a drop in line voltage, resultingin loss of power and overheating. The smaller the gaugenumber, the heavier the cord.4. When working with the air compressor outdoors, use anextension cord that is designed for outside use. This isindicated by the letters "WA" on the cord's jacket.5. Before using an extension cord, inspect it for loose or exposedwires and cut or worn insulation.Keep the extension cord clear of the workingarea. Position the cord so that it wilt not get caught on lumber,tools, or other obstructions while you are working with a powertool. Failure to do so can result in serious personal injury.Check the extension cords before each use.If damaged, replace immediately. Never use the air compres-sor with a damaged cord since touching the damaged areacould cause electrical shock resulting in serious personalinjury.NOTE: Use longer air hoses instead of long extension cords.Your air compressor will run better and last longer.ELECTRICAL CONNECTION1. This air compressor is powered by a precision built electricmotor. It should be connected to a power supply that is 120volts, 60 Hz, AC only (normal household current).2. Do not operate this tool on direct current (DC). A substantialvoltage drop wilt cause a loss of power and the motor willoverheat. If the air compressor does not operate whenplugged into an outlet, double check the power supply.SPEED AND WIRING1. The no-load speed of the electric motor varies by model andspecification. The motor speed is not constant and decreasesunder a load or with lower voltage. For voltage, the wiring in ashop is as important as the motor's horsepower rating.2. A line intended only for lights cannot properly carry a powertool motor. Wire that is heavy enough for a short distance wiltbe too light for a greater distance. A line that can support onepower tool may not be able to support two or three tools.GROUNDING INSTRUCTIONS1. In the event of a malfunction or breakdown, groundingprovides a path of least resistance for electric current toreduce the risk of electric shock. This air compressor isequipped with an electric cord having an equipment-groundingconductor and a grounding plug. The plug must be pluggedinto a matching outlet that is properly installed and groundedin accordance with all local codes and ordinances.2. Do not modify the plug provided. If it wilt not fit the outlet, havethe proper outlet installed by a qualified electrician.3. The conductor with insulation having an outer surface thatis green with or without yellow stripes is the equipment-grounding conductor. If repair or replacement of the electriccord or plug is necessary, do not connect the equipment-grounding conductor to a live terminal.4. Check with a qualified electrician or service personnel if thegrounding instructions are not completely understood, or if indoubt as to whether the tool is properly grounded.5. Replace a damaged or worn cord immediately.Improper connection of the equipment-grounding conductor can result in a risk of electric shock.6. This air compressor is intended for use on a circuit thathas an outlet like the one shown in the figure 1. It also hasa grounding pin like the one shown. This product must begrounded.Fig. 1Grounding pin120V Grounded outlet7. Never use an electrical adapter with this grounded plug.