Cisco Profile Series Installation Sheet
Also see for Profile Series: User guideGetting started guideGetting started guideGetting started guideUser guide
Installing Cisco TelePresence System Profile 42”/52”Page 178-19778-01 Profile 42-52 Installation Sheet | December 2010 | © 2010 Cisco Systems, Inc. All rights reserved.3 A + B: Mounting the stand-alone or the wall mounting foot modulesto complete the bottom moduleRev. Date Prep. Checked Change---Telecom AS ------------------Part weight:Sheet size:Scale:Surface treatmentSpecification: MaterialTolerancesUnit:EuropeanprojectionSheet 1 of 1All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -ProcessesType:Manufacturer:Type number:Thickness:Color:Surface:Glossiness:Flame class:UL reference:3D CAD model file 120800 rev. 03A+ is masterColumn 42/52 w/steel frame120800 rev.23617gA3mm1:4---Telecom AS ------------------Part weight:Sheet size:Scale:Surface treatmentSpecification: MaterialTolerancesUnit:EuropeanprojectionSheet 2 of 2All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -ProcessesType:Manufacturer:Type number:Thickness:Color:Surface:Glossiness:Flame class:UL reference:3D CAD model file 117324 rev. 00E+ is masterTANDBERG Aquarius 52"117324 rev.00A+53908gA3mm1:5Rev. Date Prep. Checked Change---Telecom ASPart weight:Sheet size:Scale:TolerancesUnit:EuropeanprojectionSheet 1 of 1All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -Processes3D CAD model file 120800 rev. 03A+ is masterColumn 42/52 w/steel frame120800 rev.23617gA3mm1:41 Unpack the foot module (stand-alone, wall mounting or wheelbase)Lift out to openthe snap lockers2 Remove the outer cover and locate the boxes for the monitor, column, camera, touch screen and accessoriesC Wheelbase foot module3 C: Mounting the wheelbase foot moduleThe accessories box contains:• Microphones, 2 or 3 pcs.• Remote control and 4 AAAbatteries• Cleaning cloth• Power cables• Two M8×60 screwsPRECAUTIONSPlease follow the steps in this installation guide when unpackingand assembling Profile 42”/52”. A minimum of two (2) persons arerequired when installing Profile 42”/52”.UNPACKING THE SYSTEM AT THE DESTINATIONIt is highly recommended to start the unpacking and assembling ofProfile 42”/52” at the place where the system is to be used.NOTE: If it is not possible to bring the complete delivery to the roomwhere Profile 42”/52” is to be used, then unpack (step 1–2) andbring the smaller units to the destination.• The monitor box requires two (2) persons to lift(42” 110 lb / 50 kg, 52” 132 lb / 60 kg)• The column requires two (2) persons to lift (55 lb / 25 kg)• The stand-alone foot module requires two (2) persons to lift (55 lb /25 kg)INSTALLATION NEAR A SOCKET-OUTLETThe equipment must be installed near a socket-outlet. The socket-outlet shall be easily accessible after installation.ROOM GUIDELINESNOTE: The floor must be in level.The recommended distance between the Profile 42”/52” andthe meeting room table should be minimum 59 in. / 150 cm.Read more about room guidelines in the Video conferencing roomprimer.USER DOCUMENTATIONThe user documentation for this product, including compliance andsafety information, is available on the Cisco web site.Go to: http://www.cisco.com/go/telepresence/docs.DIMENSIONS OF PROFILE 42”The assembled unit has the following dimensions:• Height: 59.9 in. / 152 cm• Width: 38.6 in. / 98 cm• Depth: Stand-alone: 26.8 in. / 68 cmWall mounting: 8.9 in. / 23 cm (brackets included)Wheelbase: 31.8 in. / 81 cm• Weight: 231.5 lb / 105 kgDIMENSIONS OF PROFILE 52”The assembled unit has the following dimensions:• Height: 63.6 in. / 162 cm• Width: 47.4 in. / 121 cm• Depth: Same as for Profile 42”• Weight: 253.5 lb / 115 kgProfile 42”/52” contains:MonitorBottom module:• Column• Foot module (stand-alone, wheelbaseor wall mounting)Front grille (inside foot module box)Speaker grille (inside monitor box)CameraMicrophones, 2 or 3 pcs.Touch Screen CSRemote controlCables, screws and toolsCleaning cloth1. Open the snap lockers.2. Lift out the foot module box.3. Open the box and unpack thefoot module.A Stand-alone foot module (55 lb /25 kg)CAUTION: You need two persons to mount the columnto the foot module. Take care to hold the modules firmlyduring installation.1. Unpack the column. Hold it firmly while moving the footmodule towards the bottom of the column, aligning theholes for the screws.2. Fasten the four M8×50 screws with theAllen key.3. Raise the bottom module.CAUTION: You need two persons to mount thecolumn to the wheelbase. Take care to hold themodules firmly during installation.1. Unpack the column. Hold it firmly while movingthe wheelbase towards the bottom of thecolumn, aligning the holes for the screws.2. Use the Allen key, which isfound in the foot modulebox, to fasten the fourM8×30 screws.3. Raise the completebottom module.B Wall mounting foot moduleFastening the front grilleThe front grille is attached using one M6×16 screw (upperscrew) and one M6×10 screw (lower screw) on each side, asillustrated to the right. Use the Torx key.The grille and Torx key are found in the foot module box. Thescrews are premounted in the grille and bottom module.Follow these steps to fasten the grille:4. Remove the two upper screws from the grille.5. Loosen the two lower screws in the bottom modulewithout removing them.6. Place the front grille below the front door, as illustratedto the right. Tilt the front grille to get the brackets behindthe front door and slide the grille on to the lower screws.7. Open the front door to gain access to the screws.a) Insert the upper screws without tightening them.b) Close the front door to align the grille.c) Open the front door again, and tighten the lowerscrews through the hole.d) Tighten the upper screws.Hole to accessthe lower screw Front doorFront grilleUpper screw(M6×16)CAUTIONHEAVYCameraAccessories boxTouch screenMonitor(42” 110 lb / 50 kg,52” 132 lb / 60 kg)Rev. Date Prep. Checked Change---Telecom AS -----------------Part weight:Sheet size:Scale:Surface treatmentSpecification: MaterialTolerancesUnit:EuropeanprojectionSheet 1 of 1All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -ProcessesType:Manufacturer:Type number:Thickness:Color:Surface:Glossiness:Flame class:UL reference:3D CAD model file 121608 rev. 01 is master121608 rev.gA3mm1:7Column(55 lb /25 kg)The foot module box contains:• Foot module (stand-alone, wallmounting or wheelbase)• Front grille (not for wheelbase)• Four M8×50 screws (not forwheelbase)• Four M8×30 screws (wheelbaseonly)• Wall brackets and four M6×10screws (wall mounting only)• Allen key• Torx key (not for wheelbase)• Level adjustment tool, orange(stand-alone only)Foot module boxRev. Date Prep. Checked Change---Telecom AS ------------------Part weight:Sheet size:Scale:Surface treatmentSpecification: MaterialTolerancesUnit:EuropeanprojectionSheet 1 of 2All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -ProcessesType:Manufacturer:Type number:Thickness:Color:Surface:Glossiness:Flame class:UL reference:3D CAD model file 117324 rev. 00E+ is masterTANDBERG Aquarius 52"117324 rev.00A+53908gA3mm1:7Rev. Date Prep. Checked Change---Telecom AS ------------------Part weight:Sheet size:Scale:Surface treatmentSpecification: MaterialTolerancesUnit:EuropeanprojectionSheet 1 of 2All materials, finishes, and proccessesmust comply with the RoHS directivesDimensions without paint or finishFlame class requirement: -ProcessesType:Manufacturer:Type number:Thickness:Color:Surface:Glossiness:Flame class:UL reference:3D CAD model file 117324 rev. 00E+ is masterTANDBERG Aquarius 52"117324 rev.00A+53908gA3mm1:7Detailed illustration, left hand side.Right hand side is similar.Lower screw(M6×10)Detailed illustration from inside, lefthand side. Right hand side is similar.CAUTIONHEAVYUnpacking and assembling Profile 42”/52”CAUTIONHEAVY |
Related manuals for Cisco Profile Series
Cisco TelePresence Profile 55 Dual Installation Sheet
Cisco TelePresence System Profile 52” Dual Installation Sheet
Cisco MCU 5300 series Installation Manual
Cisco TelePresence C20 Installation Sheet
Cisco Tandberg 1700 MXP Installation Sheet
Cisco TANDBERG Edge MXP Installation Sheet
Cisco TelePresence Profile 55 Installation Manual
Cisco TelePresence SX Series Installation Manual
Cisco Profile Series User Manual
Cisco TelePresence SX20 Quick Set Installation Sheet
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved