Cisco D9800 Installing Manual

Also see for D9800: Reference guide Configuration guide Getting started

Installing the D9800 Network Transport ReceiverThis section contains the information for technicians installing the Cisco D9800 Network Transport Receiver.Allow only authorized and qualified service personnel to install, operate, maintain, and service this product.Otherwise, personal injury or equipment damage may occur.Warning• Safety Guidelines, page 1• Mounting a D9800 Receiver to a Rack, page 2• Rear Connector Panels, page 3• Connecting AC Power to the D9800 Receiver, page 5• Connecting to the Satellite Input, page 6• Connecting the Input/Output Signals, page 6• External Alarm System Connector, page 9• Connecting the Ethernet Management Interface, page 11• Viewing the Hardware Information, page 11Safety GuidelinesThis section describes general safety guidelines prior to installing and connecting the D9800 receiver.CoolingThe unit is cooled by the use of internal fans. The air intake is from the front and the air outlet is on the rear.The inlet air temperature must not exceed 50°C/122°F at any time.CautionCisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide1