Cisco D9800 Configuration Manual

Also see for D9800: Reference guide Getting started Installing manual

Contents

Configuring the Transport Stream InformationThis section describes how to set up and configure the transport stream outputs in the D9800 NetworkTransport Receiver.• Transport Stream Outputs, page 1• Configuring the ASI or MPEGoIP Output General Settings, page 3• Configuring the ASI or MPEGoIP Output Mode, page 4• Configuring the MPE Settings, page 7• Setting Up Redundancy Controls for MPEG over IP and MPE Outputs, page 8• Synchronizing the Output Services, page 9• Resolving Conflicts, page 13• Setting up the DPM Program Entries, page 13• Copying between ASI and MPEGoIP DPM Settings, page 17• Configuring the Program Entries, page 17• Setting the SAP IP Address, page 21• Setting the Transport Packet Limits, page 21• Configuring the Forward Error Correction Settings, page 22• Configuring MPEG over IP or IP Data Streams, page 25• Configuring the Transcoder Settings, page 26Transport Stream OutputsThe ASI and MPEGoIP transport outputs are individually configurable and provide the capability of carryinga decrypted program for digital tier distribution. This helps the compressed video programs are efficientlydistributed to households equipped with digital set-top boxes. Digital Program Insertion (DPI) informationwill also be available along with the video and audio PIDs (Packet Identifiers) for external ad insertion incompressed digital format.Cisco D9800 Network Transport Receiver Version 3.01 Installation and Configuration Guide1