Cisco D9800 Getting Started

Also see for D9800: Reference guide Configuration guide Installing manual

Contents

Getting StartedThis section describes how to use the D9800 Network Transport Receiver front panel and web GUI, as wellas how to initially set up the D9800 receiver. There are two ways to configure the D9800 unit: front paneland web GUI. For example, changes made through the front panel is reflected on the web GUI, and viceversa.• About the Front Panel, page 1• Logging on to the D9800 Web GUI, page 7• Basic Vs. Advanced Mode, page 10• Quick Setup, page 10About the Front PanelYou can use the controls and indicators on the front panel to operate the D9800 receiver. These include thenumeric keypad, the navigation or selection keypad, the LCD, the alarm and signal indicators. These areshown in the following illustration.Figure 1: D9800 Front PanelLCDThe LCD provides information on the selections available at any menu level, current settings for parameters,and certain status and alarm indications. This is a 2x40, backlit LCD display. The top line may be status dataCisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide1