Canon imageFORMULA ScanFront 400 Set Up And Operation Manual

Also see for imageFORMULA ScanFront 400: Service guide

Contents

Canon imageFORMULA ScanFront 400 Set Up And Operation Manual Manual pdf 52 page image

52 Chapter 4 Operating Procedures1. Flow of Scanner OperationsThe procedure and screen transitions for the process from turning the scanner ON, to sending an image file are as follows. Fordescriptions of the various settings, refer to the appropriate reference pages.Turn the power ON (See p. 53.)No user is registered* When no user is registered and onlythe Shared Address Book and SharedJob Button are usedHome screen(See p. 59.)* Set the screen that appears after login in the user settings.* When you use server authentication, the user that logged inis registered automatically.Job Button screen(See p. 60.) * Users restricted by [Use only JobButtons] in the functionrestrictions cannot scan from theHome screen.Scanning starts immediately after ajob button is pressed.Administrator Settings screen(See p. 29.)User Settings screen(See p. 80.)* The administrator password isregistered in the AdministratorSettings screen, and the userpassword is registered in the UserSettings screen.Scan / Send Settings screen (Refer to p. 85 of the ScanFront 400INSTRUCTIONS.)Scan (The process after scanning differs depending on the Send Settings)(Refer to p. 98 of the ScanFront 400 INSTRUCTIONS.)Scanning finishes (A document confirmation message appears) (See p. 68.)The documentand image arenot checkedAfter scanning of thedocument ends, the image issent as is and the processends.Send/Image Confirmation screen (See p. 68.)Address Confirmation screen (See p. 70.)The image is sentwithout the addressbeing confirmed.Send (The screen displayed after sending differs depending on the Send Settings)(Refer to p. 98 of the ScanFront 400 INSTRUCTIONS.)Home screen Job Button screen Login screenLogin screen (See p. 55.)Address selection screen(See p. 62.)Password setting screen(Refer to p. 157 of the ScanFront400 INSTRUCTIONS.)* Send Settings are alsoapplied to job buttons.Users are registered (device/server authentication)