Back Previous Page Next PageContents982. Removing and Attaching the Rollers andDocument Holding GuideTo clean or replace the feeding roller, retard roller, or document holding guide,remove and then attach the parts as described in each respective section.CAUTIONDo not use excessive force when removing or attaching the rollers anddocument holding guide. Doing so many damage them.When the rollers have fed more than 100,000 pages, a roller replacementmessage appears on the computer. Purchase an exchange roller kit and replacethe feeding roller and the retard roller.IMPORTANT• Rollers are consumable parts. When the rollers start to wear out, paper jamsand misfeeds may occur more often. When this happens, purchase anexchange roller kit and replace the feeding roller and the retard roller.• If misfeeds occur often, check the rollers for wear, and replace them ifnecessary before the message is displayed.• Make sure to reset the counter after replacing the rollers (See "Resetting theCounter," on p. 98.).• For information about the exchange roller kit (feeding roller, retard roller,)contact your local authorized Canon dealer or service representative.After replacing the feed rollers, open the counter settings dialog box and resetthe counter.Under Windows1 From the Windows task bar, click [Start] → [Control Panel].2 Double-click [Printers and Other Hardware] in the working field → click[Scanners and Cameras].Control Panel (Category View) Printers and Other HardwareRoller Replacement CycleResetting the Counter
