Error Code Table 6-5Appendix6Error Code TableIf an error occurs when transmitting or receiving an I-Fax, an error code will bedisplayed on each report.This section describes specific error displays of I-Fax.When a transmitting job is not completed properly, the completion code is printedon the RESULT column of the Activity Report or the TX Report. Take therecommended solution procedure that corresponds to the completion code.NOTEFor error codes displayed while performing normal fax transmitting and receiving, seeChapter 12, "Troubleshooting," in the Facsimile Guide.Completion Code Meaning Solution#0037 -The memory is full (Memoryfor I-Fax reception is full).-Reception is rejectedbecause the printer is notready to print.-Wait until automaticallyrecovered.-Print out documents storedin the memory withMEMORY RX orRECEIVED IN MAIL BOX.-If an error occurs in theprinter, eliminate the cause.#0751 -FTP server is not set up.-The network with the FTPserver is cut off. (Cannotconnect to the destination, orthe line is severed in themiddle.)-Check the destination.-Check the network.-Check the FTP serversettings.#0752 -Incorrect settings of SMTP/POP3 server name for e-mailor I-Fax.-The server is not set up.-The network is cut off.-Check settings of theSMTP/POP3 server namein Additional Functions.-Check that the SMTP/POP3 server worksproperly.-Check the networkconditions.
