Canon i470D Printing Manual

Also see for i470D Series: Printing guide Setup instructions Quick start guide Quick start guide Service manual

Contents

Canon i470D Printing Manual Manual pdf 39 page image

Troubleshooting39 An Error Icon is Displayed on the Operation Panel.302302302302Paper jammed.Remove the jammed paper, load paper, and press the ResumeResumeResumeResume button.402402402402No print head is installed.Install the print head following the instructions given in the Easy SetupInstructions.403403403403The print head is faulty.Turn off the printer by pressing the PowerPowerPowerPower button, then turn on theprinter again.If the same error persists, the print head may be faulty. Contact theCustomer Care Center.611611611611A specified period of time has lapsed withoutreceiving a response from the digital camera.Press the ResumeResumeResumeResume button.The digital camera will automatically turn on. If not, turn it on.612612612612This printer is not ready for the connecteddigital camera or digital video camcorder.Disconnect the camera connection cable, press the ResumeResumeResumeResume button, andthen connect the cable once more.If the error is still unresolved, there is a possibility that you are using adigital camera or digital video camcorder that is not supported by thisprinter.Connect a Canon “Bubble Jet Direct” compatible digital cameras ordigital video camcorders.802/804/806/807/808/809802/804/806/807/808/809802/804/806/807/808/809802/804/806/807/808/809An error requiring a service may have occurred.Turn off the printer, remove the power cord plug from the outlet, plug thepower cord back in, and then turn on the printer again.If the same error persists, contact the Customer Care Center.Note If the Same Error PersistsIf the same error persists after a countermeasure is taken according to theabove error number, turn off the printer, remove the power cord plug from theoutlet, plug the power cord back in, and then turn on the printer again.Error Icon/Problem Try Thisstays lit.The memory card is insertedincorrectly.Insert an available memory card after checking its orientation. See “Using aMemory Card” on page 8.If a memory card has already been inserted, remove it and then insert it again.Next, check that the Indicator lamp stays on.is flashing.The memory card cannot be read.Image data edited/processed on the computer must also be printed from thecomputer.The ???? mark is displayed beside the inktank icon.An ink counter has not been reset afterreplacement of the relevant ink tank.After replacing an ink tank with a new one, reset the relevant ink counter. See“Replacing an Ink Tank” on page 34.Error Number/Problem Try ThisNote Never remove the card while image data is being read (theIndicator lamp is flashing).