Off, On"Setting the Permission for HTTP Communications"Port Number Settings Depending on your network environment, you can change the port number for each protocol.LPD: 1 to 515 to 65535RAW: 1 to 9100 to 65535HTTP: 1 to 80 to 65535POP3 RX: 1 to 110 to 65535SMTP TX: 1 to 25 to 65535SNMP: 1 to 161 to 65535WSD Search: 1 to 3702 to 65535Multicast Discovery1 to 427 to 65535"Setting Protocol Port Numbers"MTU Size Select MTU.1300, 1400, 1500SNMP SettingsYou can monitor and control the machine using an SNMP-enabled device."Monitoring/Controlling Devices by SNMP (SNMP Setting)"Settings DescriptionsSNMPv1 Settings Specify whether to use SNMPv1, and set the Community Name and access rights used bySNMP.OffOnCommunity Name 1: PublicCommunity Name 2: Not SetMIB Access Permission 1: Read Only, Read/WriteMIB Access Permission 2: Read Only, Read/WriteDedicated Community Settings: Off, Read/Write, Read Only"Setting SNMPv1"SNMPv3 Settings Specify whether to use SNMPv3.Off, On"Setting SNMPv3"Printer ManagementInformation From HostSpecify whether to acquire printer management information periodically from host.Off, On"Obtaining Printer Management Information from Host"Dedicated Port SettingsSet to enable or disable the dedicated port.If the dedicated port is set to be disabled, you cannot scan/print, or configure/check the settings for this product whenusing the printer driver or the MF Toolbox by connecting the network.Off, On"Setting the Dedicated Port"㻣㻤㻥㻌㻛㻌㻥㻢㻠Downloaded from ManualsPrinter.com Manuals
